Turning of hardened 100Cr6 bearing steel with ceramic and PCBN cutting tools

By G. Benga, Alexandre M. Abrão. 2003

170 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/a28360a7dedf2a8b01bb4c87727cc97368e744ec

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. Y. Şahin
2. Tarek Mabrouki
3. S. Basavarajappa
4. R. Suresh
5. G. Samuel
6. V. Gaitonde
7. Jean François Rigal
8. Song Zhang

In Electrical and Electronic Engineering

1. Y. Şahin
2. Tarek Mabrouki
3. M. Yallese
4. S. Basavarajappa
5. R. Suresh
6. G. Samuel
7. V. Gaitonde
8. Jean François Rigal

In Mechanical Engineering

1. Tarek Mabrouki
2. Y. Şahin
3. M. Yallese
4. S. Basavarajappa
5. R. Suresh
6. G. Samuel
7. V. Gaitonde
8. Jean François Rigal

Citations in the corpus

• Surface roughness model in machining hardened steel with cubic boron nitride cutting tool (2008, methodology): “Benga and Abrao [2] showed that cutting speed was the factor which most affected tool life when turning hardened 100Cr6 bearing steel, which is not the case for the present work.”
• Empirical models and optimal cutting parameters for cutting forces and surface roughness in hard milling of AISI H13 steel (2010, background): “Benga and Abrao [ 7 ] investigated the effects of speed and feed rate on surface roughness and tool life when machining hardened 100Cr6 bearing steel (62–64 HRc) using ceramic and CBN tools.”
• Comparison of tool life between ceramic and cubic boron nitride (CBN) cutting tools when machining hardened steels (2009, methodology): “Similar results were obtained with previous works carried out by Lima et al.(2005), Jang et al.(2000); Sahin (2006), Benga and Abrao (2003), Chou et al.(2002), Yang and Tarng (1998), Davim and Figueira (2006).”
• Machinability investigations on hardened AISI 4340 steel using coated carbide insert (2012, background): “Benga and Abrao [47] and Kumar et al.”
• Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN tool (2010, background): “In their experimental research work, Benga and Abrão [12] underlined that feed rate is most significant factor affecting surface finish than cutting speed for both CBN and ceramic inserts.”