Investigations on hard turning with minimal cutting fluid application (HTMF) and its comparison with dry and wet turning

By A. Varadarajan, P. Philip, B. Ramamoorthy. 2002

272 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Ecological Modeling, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/880eaca34d946f9f552d2a48e90344c5c47e91fa

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Ecological Modeling

Nikhil Ranjan Dhar

In Mechanical Engineering

Citations in the corpus

The effect of cutting fluids applied in metal cutting process (2016, background): “Cutting fluid applied as a high-velocity thin pulsedjet was investigated during hard turning of hardened steel, compared with conventional coolant and dry cutting.(27) The overall performance of minimal cutting fluid application was found to be superior to those of the other two on the basis of main”
Mechanism of minimum quantity lubrication in high-speed milling of hardened steel (2007, background): “Several studies on the application of MQL in machining of steels had been conducted [4–14].”
Performance evaluation of minimum quantity lubrication by vegetable oil in terms of cutting force, cutting zone temperature, tool wear, job dimension and surface finish in turning AISI-1060 steel (2006, background): “Varadarajan et al.(2002) developed alternative test equipment for injecting the fluid and used it with success in hard turning for which a large supply of cutting fluid is the normal practice.”
CBN tool wear in hard turning: a survey on research progresses (2007, background): “Minimal cutting fluid approaches have been pioneered in hard turning too, and reduced flank wear rate has been observed when applying little mineral oil based cutting fluid in turning hardened AISI 4340 steel [50].”
Feasibility study of the minimum quantity lubrication in high-speed end milling of NAK80 hardened steel by coated carbide tool (2007, background): “With respect to steels, the researches and applications of MQL are mainly focused on the drilling and turning operations [10,13–18].”
An optimization method of the machining parameters in high-speed machining of stainless steel using coated carbide tool for best surface finish (2012, background): “performance compared to dry and conventional flood machining [3, 9, 17, 18].”