Shaped metal deposition of a nickel alloy for aero engine applications

By D. Clark, M. Bache, M. Whittaker. 2008

222 citations recorded by the source corpus.

Subfields: Aerospace Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/66f18cda0b8e38d6cf83e00b9b559d596aa2c29b

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Aerospace Engineering

1. T. DebRoy
2. T. Mukherjee
3. H. Wei
4. J. Elmer
5. Amitava De
6. Carlos Agelet de Saracibar
7. B. Baufeld
8. Miguel Cervera

In Mechanical Engineering

1. T. DebRoy
2. T. Mukherjee
3. H. Wei
4. Amitava De
5. J. Elmer
6. Wei Zhang
7. Stewart W. Williams
8. J. Zuback

Citations in the corpus

• Microstructure of selective laser melted CM247LC nickel-based superalloy and its evolution through heat treatment (2016, background): “As such, the amenability of this class of alloys to processing by AM techniques, including SLM, has received much interest [5-7].”
• The Current State of Research of Wire Arc Additive Manufacturing (WAAM): A Review (2021, background): “University of Wales Swansea Shaped metal deposition [43]”
• Wire and arc additive manufacturing: Opportunities and challenges to control the quality and accuracy of manufactured parts (2021, background): “This affects the thermal gradients and cooling rates, which in turn influence residual stress andmicrostructure [81].”
• Laser polishing of selective laser melted components (2015, background): “Over the last few years this process has gained increasing attention due to the rapid development in the capabilities of additive manufacturing [4, 5].”
• Structure, Texture and Phases in 3D Printed IN718 Alloy Subjected to Homogenization and HIP Treatments (2017, unknown): “This phase was surprisingly termed as Laves phase by [16,44]; however, it has different chemical composition than (Ni,Cr,Fe)2(Nb,Mo,Ti) as reported by [45–47].”
• Additive manufacturing of metallic components – Process, structure and properties (2018, background): “The intermetallic compound forms near the final stage of solidification and its size is largely affected by the cooling rate [457,459].”
• Additive manufacturing of Ti–6Al–4V components by shaped metal deposition: Microstructure and mechanical properties (2010, background): “Basically, three different additive manufacturing techniques for metals are currently under investigation: direct laser deposition [1–10], electron beam deposition [8,9,11,12] and shaped metal deposition (SMD) [13–20], which latter utilizes tungsten inert gas (TIG) welding.”
• Wire + Arc Additively Manufactured Inconel 718: Effect of post-deposition heat treatments on microstructure and tensile properties (2019, methodology): “Deposition of IN718 using WAAM techniques has been demonstrated to be viable in several studies using metal-inert-gas (MIG) [6], tungsten-inert-gas (TIG) [7–9] and cold metal transfer (CMT) [10], although careful control of build parameters is necessary to prevent porosity and crack-like defects.”
• Thermo-mechanical analysis of Wire and Arc Additive Layer Manufacturing process on large multi-layer parts (2011, unknown): “Finally, WAALM can be used to deposit a variety of materials that can be welded, such as steel [4, 5], Ni alloys [6], and Ti alloys [1, 7].”