The Design of CMOS Radio-Frequency Integrated Circuits

By Brian A. Ellis. 2004

3,882 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering

View Paper: https://www.semanticscholar.org/paper/2022be3bdc742dd0eb4f7897db564ab80b4d69fa

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

Citations in the corpus

A 3–10-GHz Low-Power CMOS Low-Noise Amplifier for Ultra-Wideband Communication (2011, background): “Resonance frequency plays a key role in obtaining the desired 50- input impedance in the whole 3–10-GHz range.”
Distributed active transformer-a new power-combining and impedance-transformation technique (2002, background): “Two major problems associated with the design of on-chip power amplifiers using submicrometer CMOS processes are low transistor breakdown voltage [11] and the high loss of on-chip impedance transformation [12].”
Closed-Form Expressions of 3-D Via Resistance, Inductance, and Capacitance (2009, background): “The resistance at a frequency of 1 GHz, however, is also dependent on the skin depth, which is the depth below the surface of a conductor where the current density has dropped by a factor of e [24].”
Ambient backscatter: wireless communication out of thin air (2013, background): “oscillators and power amplifiers at the transmitter [30, 16] and low noise amplifiers, mixers, oscillators and ADCs at the receiver [30, 16].”
30-100-GHz inductors and transformers for millimeter-wave (Bi)CMOS integrated circuits (2005, background): “The peaking inductance can be chosen to give maximum bandwidth extension [16]”
Analysis and design of a 1.8-GHz CMOS LC quadrature VCO (2002, background): “In fact, the current noise power spectral density is proportional to [22], while the noise transfer into the tank is given by .”
A low-power, low-noise CMOS amplifier for neural recording applications (2002, neutral): “signal [29].”
Transmission line approach of left-handed (LH) materials and microstrip implementation of an artificial LH transmission line (2004, methodology): “Further improvement possibilities include using -derived matched-sections [37] or stages with different , such as based on standard low-pass prototype.”
New Architectures for Radio-Frequency DC–DC Power Conversion (2006, background): “6] and the inverse of the normalized power handling capability defined in [52] and [53], except that we normalize to the power per switch, to better capture the limits of multiswitch topologies.”
Full-Duplex Wireless Communications: Challenges, Solutions, and Future Research Directions (2016, background): “, 40 dB higher than the receiver noise floor level of 90 dBm [58].”
Square-extensional mode single-crystal silicon micromechanical resonator for low-phase-noise oscillator applications (2004, neutral): “The T-type corner anchoring is used for reducing the energy leakage to the substrate.”
The physics of optical computing (2023, background): “While this is true, a counterpoint is that even though the wave nature of individual electrons is impractical to observe, wave phenomena of microwave signals in electronics can easily be observed and exploited for computation [132].”
Energy-Efficient Routing Protocols in Wireless Sensor Networks: A Survey (2013, background): “The P A ( d ) , will depend on many factors including the speci ﬁ c hardware implementation, DC bias condition, load characteristics, operating frequency and P A output power, P Tx [26].”
Full duplex radios (2013, background): “Prior designs also need to have at least two antennas [11, 5] in place of the one used by half duplex systems (one each for transmit and receive and possibly more [3]).”