On the Nature of Critical Heat Flux in Microchannels
By A. Bergles, Satish G. Kandlikar. 2003
303 citations recorded by the source corpus.
Subfields: Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/089882069cf7246e50807b0d81648561baff540d
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Mechanical Engineering
- Satish G. Kandlikar
- Suresh V. Garimella
- Guodong Wang
- A. Bergles
- Ping Cheng
- T. Harirchian
- John Richard Thome
- I. Mudawar
Citations in the corpus
- High Flux Heat Removal with Microchannels—A Roadmap of Challenges and Opportunities (2005, background): “A recent paper by Bergles and Kandlikar [14] summarizes the nature of these instabilities.”
- Surface Structure Enhanced Microchannel Flow Boiling (2016, background): “This dry-out severely limits the heat removal ability of these microchannel heat sinks and leads to device failure once reaching CHF [11].”
- State-of-the-Art Overview of Boiling and Two-Phase Flows in Microchannels (2006, background): “As noted by Bergles and Kandlikar [5] in their literature review, there are apparently no available data for single microchannels with an internal diameter below 0.”
- A review of small heat pipes for electronics (2016, background): “fabrication may make it possible to realize higher power levels (Bergles and Kandlikar [152]).”
- Enhanced flow boiling in a microchannel with integration of nanowires (2012, background): “Entrained air bubble and flexible hose in the upstream of the test section causes the vapor bubble to backflow to start the instability [27].”
- Effects of inlet/outlet configurations on flow boiling instability in parallel microchannels (2008, methodology): “In recent years, two-phase flow instabilities in microchannels have attracted considerable attention [4–23].”
- Characterization of hierarchical manifold microchannel heat sink arrays under simultaneous background and hotspot heating conditions (2018, background): “The effect of channel diameter on critical heat flux is not agreed upon for conventional microchannels [39], but the critical heat flux increases with increasing hydraulic diameter for the manifold microchannels tested in this study.”