Additive Manufacturing Technologies – Rapid Prototyping to Direct Digital Manufacturing
By B. Mueller. 2012
638 citations recorded by the source corpus.
Subfields: Automotive Engineering, Building and Construction, Industrial and Manufacturing Engineering
View Paper: https://www.semanticscholar.org/paper/fa7ed2ecd41e415d71f384d9551c52b9087da5cc
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Automotive Engineering
- Biranchi Narayan Panda
- M. Tan
- Y. Tay
- S. Paul
- Weilong Cong
- Riccardo Canali
- Jordan Kalman
- A. Antonysamy
In Building and Construction
- Biranchi Narayan Panda
- M. Tan
- Y. Tay
- S. Paul
- Riccardo Canali
- Jordan Kalman
- A. Antonysamy
- Weilong Cong
In Industrial and Manufacturing Engineering
- Riccardo Canali
- Jordan Kalman
- A. Antonysamy
- Weilong Cong
- Diego Manfredi
- Georgios-Tsampikos Michailidis
- M. Pavese
- Flaviana Calignano
Citations in the corpus
- Shape optimization of a layer by layer mechanical constraint for additive manufacturing (2017, background): “D ⊂ ∂(cid:2) , and it is submitted to surface loads f ∈ L 2 ((cid”
- Additive manufacturing of metals: a brief review of the characteristic microstructures and properties of steels, Ti-6Al-4V and high-entropy alloys (2017, neutral): “In SLM [1], a laser beam scans and selectively melts a layer of powder.”
- Recycling of fiberglass wind turbine blades into reinforced filaments for use in Additive Manufacturing (2019, methodology): “AM represents a class of fabrication techniques where a layer-upon-layer method is used to build a part from a 3D model [17-19].”
- Compositionally graded metals: A new frontier of additive manufacturing (2014, background): “Equipment is available at all scales, from tabletop printers to industrial machines capable of mocking up hardware for proof-of-concepts and producing actual consumer products.(4) Figures 1(a)– 1(g) show polymer parts produced on two different classes of 3D printers.”
- Additive Manufacturing of Optically Transparent Glass (2015, neutral): “Designed lengths and diameters of crucible (1) and nozzle segments (2 & 3), along with correspondent flow resistances, are summarized in (Table 4).”
- Additive manufacturing of carbon fiber-reinforced plastic composites using fused deposition modeling: Effects of process parameters on tensile properties (2017, background): “In comparison to SLS, FDM process owns the advantages of low input energy and material cost, minimum wastage, and consistent prototype accuracy.(27,28) As shown in Figure 1, in FDM process, the filaments on the spools are fed into the liquefier head by a driver gear and a grooved bearing and extrude”