Laser powder deposition
By Lino Costa, Rui M. Vilar. 2009
164 citations recorded by the source corpus.
Subfields: Automotive Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/c396da6eb52901b7c29e6f4b6c3d8b5dce05334a
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Automotive Engineering
- Allison M. Beese
- T. Palmer
- Matthias Hirsch
- Beth E. Carroll
- Richard Leach
- A. Clare
- Mariangela Lombardi
- Paolo Fino
In Mechanical Engineering
- Allison M. Beese
- A. Saboori
- T. Palmer
- Matthias Hirsch
- Beth E. Carroll
- Donato Gallo
- Richard Leach
- A. Clare
Citations in the corpus
- Advances in additive manufacturing of metal-based functionally graded materials (2020, background): “Without material-speci fi c optimisation, laser deposited components are prone to a variety of gross defects, including porosity, lack of adherence, and undissolved powder inclusions [48].”
- An overview of Direct Laser Deposition for additive manufacturing; Part I: Transport phenomena, modeling and diagnostics (2015, unknown): “[48] L. Costa, R. Vilar, T. Reti, A.M. Deus, Rapid tooling by laser powder deposition: process simulation using finite element analysis, Acta Mater.”
- Support Structures for Additive Manufacturing: A Review (2018, unknown): “Laser powder deposition (LPD) [33] Powder materials Yes √ √ √”
- An Overview of Additive Manufacturing of Titanium Components by Directed Energy Deposition: Microstructure and Mechanical Properties (2017, background): “Although, in the case of DED parts the elongation at break (ε) is lower than that of wrought materials, because of the presence of microporosity and oxide inclusions inside the component [41,42].”
- Anisotropic tensile behavior of Ti-6Al-4V components fabricated with directed energy deposition additive manufacturing (2015, background): “In terms of differential thermal histories, the lower portion of the wall, which is closer to the baseplate, cools more rapidly than the upper portion [40], in which the heat must escape either by convection outward or conduction down the height of the wall [35].”
- Review of in-situ process monitoring and in-situ metrology for metal additive manufacturing (2016, background): “A key difference is that for DED processes, the focused energy beam is not melting a powder onto a bed, but rather delivering a powder [69] or wire into a molten pool on the substrate surface [70,71].”