Evolution of microchannel flow passages – Thermohydraulic performance and fabrication technology

By Satish G. Kandlikar, W. Grande. 2002

312 citations recorded by the source corpus.

View Paper: https://www.semanticscholar.org/paper/c2ca45d440335ffa3eeabb6e0d2b853c67db7dce

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Citations in the corpus

Review and Comparative Analysis of Studies on Saturated Flow Boiling in Small Channels (2008, background): “of different approaches for high-heat-flux cooling [6, 7] and the evolution of high-flux heat transfer approaches [8, 9], others have focused on specific topics such as flow instabilities, flow patterns, CHF [2, 10–14], and pressure drop in small tubes and channels [1].”
A comprehensive review on microchannel heat sinks for electronics cooling (2023, methodology): “Most studies adopt the former, especially the principle proposed by Kandlikar and Grande [19].”
Performance improvements of microchannel heat sink using wavy channel and nanofluids (2015, background): “wch (μm) ww (μm) Hc(μm) P (psi) q (W/cm 2 ) Rth ( o C/W) Experiment al data [1] Simulation data”
Heat Transfer in Nanofluids—A Review (2006, background): “An increasing number of studies on microchannel boiling, such as those by Kandlikar and Grande [5], Bergles et al.”
A review on heat transfer and hydrodynamic characteristics of nano/microencapsulated phase change slurry (N/MPCS) in mini/microchannel heat sinks (2018, unknown): “5 6 8 References 1 2 [1] S.G. Kandlikar, W.J. Grande, Evolution of microchannel flow passages – thermohydraulic performance and fabrication technology.”
Evaluation of Single Phase Flow in Microchannels for High Heat Flux Chip Cooling—Thermohydraulic Performance Enhancement and Fabrication Technology (2004, methodology): “A pair of photomasks was designed with a variety of features including posts and fins and printed as a transparency on an imagesetter (Grande [19]).”
Flow boiling in microchannels: Fundamentals and applications (2017, background): “Kandlikar and Grande [42] proposed different ranges based on the lower limit of channel manufacturing techniques for different heat exchangers applications.”
Nucleation characteristics and stability considerations during flow boiling in microchannels (2006, methodology): “Following the classification by Kandlikar and Grande [1], and later modifications suggested by Kandlikar et al. [2], channels with a minimum cross-sectional dimension between 200 lm and 3 mm are classified as minichannels and between 1 lm and 200 lm are classified as microchannels.”
Towards uniformly distributed heat, mass and charge: A flow field design study for high pressure and high current density operation of PEM electrolysis cells (2019, background): “A few of those are based solely on the diameter [29, 30], some on the Eötvös number [31] and others on a series of dimensionless numbers [32].”
State-of-the-Art Overview of Boiling and Two-Phase Flows in Microchannels (2006, background): “Figure 2 shows a comparison between the transition diameters from conventional to minichannels (3.0 mm) and from minichannels to microchannels (0.2 mm) recommended by Kandlikar and Grande [2] and the variation in Dth with reduced pressure for CO2 and water.”