Residual stresses in turning: Part I: Influence of process parameters

By E. Capello. 2005

222 citations recorded by the source corpus.

Subfields: Mechanical Engineering, Mechanics of Materials

View Paper: https://www.semanticscholar.org/paper/af03034852222690a9082b8775ac425fc5e2596c

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Mechanical Engineering

1. I. S. Jawahir
2. Y. Kaynak
3. O. Dillon
4. Tao Lu
5. José C. Outeiro
6. Rachid M'Saoubi
7. B. Erdem Alaca
8. Durul Ulutan

In Mechanics of Materials

1. Y. Kaynak
2. José C. Outeiro
3. Rachid M'Saoubi
4. O. Dillon
5. I. S. Jawahir

Citations in the corpus

• A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, background): “Capello (2005) showed the effects of feed rate, tool nose radius, depth of cut and cutting edge angle on the axial residual stresses developed in turning, and developed a regression analysis to include these variables.”
• Analytical modelling of residual stresses in machining (2007, background): “In the same work [17], an increase in the depth of ut is observed to lead to a reduction in compressive stresses at he entry and increase in tensile stresses at the exit, while there re reports describing the effect of the depth of cut on residual tresses as minimal [4].”
• Cryogenic Machining-Induced Surface Integrity: A Review and Comparison with Dry, MQL, and Flood-Cooled Machining (2014, background): “Therefore, among surface integrity characteristics, the residual stress plays a key role (Capello, 2005).”