Process

By Ruyi Ding, Yao Xie, Liyan Xie, Shixiang Zhu, Rui Zhang, Yuchi Henry Shaowu, Minghe Zhang, H. Yang, Sen Wang, Shengyang Dai and 1 more. 2020

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Citations in the corpus

Grammar-Based Grounded Lexicon Learning (2022, background): “According to lexicalist linguistic theories [32, 39, 10], syntactic knowledge involves a small number of highly abstract and potentially universal combinatory rules, together with a large amount of learned information in the lexicon: a rich syntactic type and meaning representation for each word.”
Materials, technological status, and fundamentals of PEM fuel cells – A review (2020, background): “Graphite [94], self-assembled graphene film [95], and diamond-like coatings [96] are typical carbon-based methods, which enable corrosion protection for the substrate.”
Architected cellular materials: A review on their mechanical properties towards fatigue-tolerant design and fabrication (2021, background): “Post-build treatments are often necessary to mitigate or eliminate such detrimental effects [28,30,146], to achieve final appli-”
Three dimensional printing of high dielectric capacitor using projection based stereolithography method (2016, methodology): “The newly cured layer is separated from the substrate using a two-channel sliding design based on controlled shearing force between the cured layer and the coated film on the glass substrate [24].”
Effect of substrate preheating on the texture, phase and nanohardness of a Ti–45Al–2Cr–5Nb alloy processed by selective laser melting (2016, methodology): “adopted single track experiments to optimize the SLM processing parameters for a TiAl alloy, and near-fully dense TiAl parts could be achieved [13].”
On the Precipitation Hardening of Selective Laser Melted AlSi10Mg (2015, background): “This is because the increase in precipitate size would require more energy from the dislocation to shear through so bypass is promoted [16].”
Thermal management optimization of an air-cooled Li-ion battery module using pin-fin heat sinks for hybrid electric vehicles (2015, background): “[12] investigated the thermo-mechanical properties of PCM/EG (Phase Change MaterialExpanded Graphite) composites made by paraffinwax, and showed that as mass fraction of paraffin wax increased, the thermal conductivity, tensile strength, compression strength, and burst strength were improved while t”
Interpretation of europium(III) spectra (2015, background): “studied in glasses and in crystalline inorganic compounds [381-419].”
Barium Titanate Nanostructures and Thin Films for Photonics (2020, background): “[124] Visible photoluminescence is also achieve using highly disordered states obtained with Mn doping[125] or in hollow nanofibers.[125] The SHG conversion efficiency of BaTiO3 can also be optimized.”
Additive manufacturing of structural materials (2021, unknown): “polyether ketone ketone SLS 80 300 1500 Good strength, easy removal of support powder, high cost, powdery surface [23]”
3D printing of piezoelectric element for energy focusing and ultrasonic sensing (2016, methodology): “projection-based Stereolithography method by integrating a tape casting process for nanoparticle fabrication [27] .”
On the origin of the high tensile strength and ductility of additively manufactured 316L stainless steel: Multiscale investigation (2020, background): “Furthermore, the effect of the building direction on the mechanical performances of the LENS 316L was poorly studied and rarely related to its microstructure and/or the crystallographic texture [23,26,27].”