Minimal lubrication machining of aluminium alloys

By J. Kelly, M. Cotterell. 2002

254 citations recorded by the source corpus.

Subfields: Aerospace Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/9b0255f3e4915fdda038abcbd4817d00ac942f96

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Aerospace Engineering

1. Imtiaz Ahmed Choudhury
2. Peihua Yan
3. G. Wang
4. S. A. Lawal
5. Yusoff Nukman
6. Yiming Kevin Rong

In Electrical and Electronic Engineering

1. Y. Kaynak
2. Mustafa Kurt
3. Imtiaz Ahmed Choudhury
4. Peihua Yan
5. R. Zitoune
6. G. Wang
7. Eyup Bagci
8. S. A. Lawal

In Mechanical Engineering

1. Y. Kaynak
2. Mustafa Kurt
3. R. Zitoune
4. Imtiaz Ahmed Choudhury
5. Peihua Yan
6. G. Wang
7. Eyup Bagci
8. S. A. Lawal

Citations in the corpus

• Application of Taguchi methods in the optimization of cutting parameters for surface finish and hole diameter accuracy in dry drilling processes (2009, background): “However, in the last few years, regulations concerning the environment have forced the development of cutting fluids of low environmental impact, together with the search for machining methods that avoid or minimize their use [ 1 , 2]. Besides, for many applications, the manufacturer may have desire”
• Turning of Brasses Using Minimum Quantity of Lubricant (MQL) and Flooded Lubricant Conditions (2007, unknown): “The chips produced during flood lubrication consist of loose arc chips whereas MQL produced a combination of loose arc and conical chips [15].”
• A critical assessment of lubrication techniques in machining processes: a case for minimum quantity lubrication using vegetable oil-based lubricant (2013, methodology): “…by MQLPO, MQLSE and flood conditions compared to the air blow condition at the cutting speed of 60 m/min and feed rate of 0.1 mm/rev. Similarly, Kelly and Cotterell (2002) have investigated the role of different coolant application methods in the drilling of a 30 mm aluminum alloy (ACP 5080…”
• Study of drilling of composite material and aluminium stack (2010, background): “The built-up edge is mostly mechanical than physical, which can be eliminated if the spindle speed is increased and the exit burr shall be reduced if the feed rate is increased [27].”
• A review: drilling performance and hole quality of aluminium alloys for aerospace applications (2020, unknown): “[110] Kelly J, Cotterell M. Minimal lubrication machining of aluminium alloys.”
• The effect of cutting fluids applied in metal cutting process (2016, methodology): “Ways of lubrication and heat removal from cutting process.(31) Yan et al.”