Study of drilling of composite material and aluminium stack

By R. Zitoune, V. Krishnaraj, F. Collombet. 2010

332 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/4a2e200b22da675dbda70142f184714ad2aa96a4

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

Optimization of machining parameters at high speed drilling of carbon fiber reinforced plastic (CFRP) laminates (2012, background): “It can be observed that the thrust force increases with an increase in feed owing to increase in uncut chip thickness [1] and higher impact of the fibers as the feed rate is increased [16,21].”
Natural fiber–reinforced composites: A review on material, manufacturing, and machinability (2019, background): “While tool wear occurs, axial thrust force will increase with subsequent effect on the tool life with respect to the number of holes.(100) Figure 10.”
A review: drilling performance and hole quality of aluminium alloys for aerospace applications (2020, background): “Furthermore, the high drill diameter generates larger chips due to the large cross-sectional area of the chip where more chances of tool wear occur [116].”
Hole quality assessment following drilling of metallic-composite stacks (2011, unknown): “[6] on drilling composite/aluminium stacks (comprising 4.”
The Advancement of 7XXX Series Aluminum Alloys for Aircraft Structures: A Review (2021, background): “[45] found that longer metal chips lead to a decrease in the surface quality of the composite material layer’s pores, and good broken chips can improve hole quality and extend tool life.”
Drilling of polymer matrix composites: A review (2013, background): “Zitoune et al.(18) observed that drilling at high spindle speed leads to reducing the thrust force owning to the decreasing the cutting resistance of epoxy, while the surface roughness improved due to the smearing effect of fiber particles and matrix at the higher temperature.”