American Society for Testing and Materials

By S. Esterby. 2006

3,718 citations recorded by the source corpus.

Subfields: Aerospace Engineering, Control and Systems Engineering

View Paper: https://www.semanticscholar.org/paper/89a87593333df5ef83b2dc0c26c36f846f9b5ed6

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Aerospace Engineering

In Control and Systems Engineering

Citations in the corpus

Crack propagation modelling in functionally graded materials using scaled boundary polygons (2015, positive): “the maximum circumferential stress criterion (Erdogan and Sih 1963), the maximum energy release rate criterion (Hussain et al. 1974) and the minimum strain energy density (Sih 1974) can be used to determine crack propagation.”
Fracture mechanism of a coarse-grained magnesium alloy during fracture toughness testing (2009, methodology): “Fatigue crack tests were performed before the fracture toughness test to insert a fatigue pre-crack, where the sum length of the V-notch and the pre-crack was about 5mm (¼0.5W, where W is the width), based on ASTM E399.”
Some comments on the use of cone calorimeter data (2005, background): “The cone calorimeter setup [4] was developed thoroughly to target the properties of materials [5] rather than to correspond to a special full-scale scenario of a real fire.”
Application of an average strain energy density criterion to obtain the mixed mode fracture load of granite rock tested with the cracked asymmetric four-point bend specimens (2017, background): “The maximum tangential stress based criteria [16-20], the maximum tangential strain based criteria [21-24], the minimum strain energy density based criteria [25] and the maximum energy release rate or G criterion [26] are”
Advanced Oxidation Resistant Iron-Based Alloys for LWR Fuel Cladding (2014, background): “, growth and creep) to those that are frequently inconsequential to reactor operation [2].”
The effect of fiber morphology on the tensile strength of natural fibers (2013, methodology): “ASTM C1557, Standard Test Method for Tensile Strength and Young’s Modulus of Fibers.”
A review on thermally conductive polymeric composites: classification, measurement, model and equations, mechanism and fabrication methods (2018, methodology): “Details of the test method and data analyses can be found in ASTM D5930 [75].”
LIMESTONE DUST AND WOOD SAWDUST AS BRICK MATERIAL (2007, methodology): “The other engineering properties required by the international standards such as ASTM C 67-03 [16] need to be investigated.”