Gravure printing of conductive particulate polymer inks on flexible substrates

By M. Pudas, Niina Halonen, P. Granat, J. Vähäkangas. 2005

172 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Technologies for Printing Sensors and Electronics Over Large Flexible Substrates: A Review (2015, methodology): “The microcells are engraved either by using electromechanical means or using laser [18], [33], [121], [141].”
All-Printed and Roll-to-Roll-Printable 13.56-MHz-Operated 1-bit RF Tag on Plastic Foils (2010, methodology): “The printed antennas, electrodes, and wires all showed a resistivity of 20 μΩ · cm after gravure printing with a printing speed of 5 m/min on PET foils and curing for 10 s at 150 ◦C in order to provide the maximum resonator quality factor (Q) of the printed antenna [12] while maintaining practical p”
Resistive flex sensors: a survey (2015, methodology): “Fundamental printing methods are ink jet [35, 52], spray, screen [32], flexographic or gravure [53, 54] and transfer printing [55].”
Scalability of Roll-to-Roll Gravure-Printed Electrodes on Plastic Foils (2010, background): “[19]–[21] Therefore, in this paper, we tune the surface tension of the ink to optimize the ink transfer under a constant impression roll pressure, and then set the surface tension of ink as constant.”