Fundamental analysis for visible-light communication system using LED lights
By T. Komine, M. Nakagawa. IEEE transactions on consumer electronics, 2004
3,235 citations recorded by the source corpus.
Subfields: Electrical and Electronic Engineering, Global and Planetary Change
View Paper: https://www.semanticscholar.org/paper/75db6d3adb41e9fa5ec6f9a6ac84ef620e8ad1c5
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Electrical and Electronic Engineering
- Yuanwei Liu
- Lajos Hanzo
- Zhiguo Ding
- Arumgam Nallanathan
- Harald Haas
- Maged Elkashlan
- Zhijin Qin
- Fahad Zafar
In Global and Planetary Change
- Joachim W. Walewski
- Juan-Pablo García-Vázquez
- Cesar Vargas-Rosales
- Carlos Eric Galván-Tejada
- David Muñoz-Rodríguez
- George K. Karagiannidis
- Harald Haas
- H. Le Minh
Citations in the corpus
- LED Based Wavelength Division Multiplexed 10 Gb/s Visible Light Communications (2016, methodology): “It is defined such that a monochromatic light source emitting an optical power of 1/683 Watt at 555 nm has a luminous flux of 1 lumen (lm) [10].”
- High data rate multiple input multiple output (MIMO) optical wireless communications using white led lighting (2009, methodology): “Such sources can also be modulated to provide simultaneous illumination and communication; Visible Light Communications (VLC) was conceived in Japan [1], [2], and there is increasing interest in Europe, including work in a European Commission Framework 7 project OMEGA [3]-[5].”
- Visible-Light Communications Using a CMOS-Controlled Micro-Light- Emitting-Diode Array (2012, background): “Simulations have indicated the potential for data transmission rates over several hundred Mbit/s in indoor environments [4] and data transmission rates of up to 513 Mbit/s have recently been reported by Vučić et al.”
- Fog Computing: Focusing on Mobile Users at the Edge (2015, background): “Fog server can equip different wireless interfaces, e.g., WiFi, Bluetooth and visible light communications [12] according to the specific application scenarios.”
- Visible Light Communication, Networking, and Sensing: A Survey, Potential and Challenges (2015, background): “the variance of shot noise can be calculated [23], [31] as below”
- A SPAD-Based Photon Detecting System for Optical Communications (2014, background): “AN ideal receiver for plastic optical fibre [1] or visible light communications systems [2] in the edge network is both inexpensive and sensitive.”
- Evolution of Indoor Positioning Technologies: A Survey (2017, background): “All VLC projects, as [18, 19] and Zhang et al.”
- Broadband Information Broadcasting Using LED-Based Interior Lighting (2008, methodology): “After blue-light filtering, the induced photocurrent at the assumed receiver is mA (about four times smaller than assumed in [4]), and the noise power spectral density is”
- Towards 6G Networks: Use Cases and Technologies (2019, methodology): “…mmWave pathloss follows the 3GPP models considering both Line-of-Sight (LOS) and NLOS conditions, while LOS-only is considered for Terahertz [10] and VLC [12]. networks by leveraging a set of technologies that have been enabled by recent physical layer and circuits research, but are not part of 5G.”
- Visible light communications: Challenges and possibilities (2008, background): “a room [ 8 , 9]~ or transmitted via a car headlight [5]~ \vith the”
- Visible light communication using OFDM (2006, background): “OOK (on-off keying), PCM (pulse code modulation), and SC-BPSK (sub-carrier binary phase shift keying) are some of the more popular modulation schemes used in conjunction with LED wireless systems [1].”
- Visible light communications for 5G wireless networking systems: from fixed to mobile communications (2014, methodology): “For indoor application, LED is employed as the signal source to provide short distance data transmission within a room [4], which is expected to be a desired design for next generation indoor wireless communications.”