The effect of machining on surface integrity of titanium alloy Ti–6% Al–4% V

By C. H. Che-Haron, A. Jawaid. 2005

542 citations recorded by the source corpus.

Subfields: Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/587b9983ed820b0dc762bf0dadaaa22b6407a9d3

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

Finite element simulation of high-speed machining of titanium alloy (Ti–6Al–4V) based on ductile failure model (2011, background): “However, titanium and its alloys are usually considered as extremely difficult to cut materials because of their low thermal conductivity and high chemical reactivity with cutting tool materials [2, 3].”
INVESTIGATING THE EFFECTS OF EDM PARAMETERS ON SURFACE INTEGRITY, MRR AND TWR IN MACHINING OF Ti–6Al–4V (2012, background): “Titanium alloys such as Ti–6Al–4V , because of their low toughness and low thermal conductivity and chemical reactivity with most materials of cutting tools, are classified as difficult-to-cut materials (Haron and Jawaid, 2005 ), so traditional machining of Ti–6Al–4V , economically is not so bene”
Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review (2014, background): “Jawaid et al. [85] conducted experiment on Ti—6% Al 2% Sn 4% Zr 6% Mo using two grades of fine grain size straight tungsten carbide tools.”
Cryogenic Machining-Induced Surface Integrity: A Review and Comparison with Dry, MQL, and Flood-Cooled Machining (2014, background): “…173 in the deformed layer, the hardness at the surface is much higher than in the base metal, and it was shown to exponentially reduce with increasing depth from the surface until it reaches the bulk material hardness value at a certain depth (Che-Haron and Jawaid, 2005; Okushima and Kakino, 1969).”
Effect of single and multi-channel electrodes application on EDM fast hole drilling performance (2010, background): “Inconel 718. Ti–6Al–4V is the α+β-type titanium alloy, which is chemically reactive with almost all cutting tools, and its low thermal conductivity and low modulus of elasticity also impair machinability [ 13 ].”