Influence of steam heating on the properties of pine (Pinus pinaster) and eucalypt (Eucalyptus globulus) wood

By B. Esteves, A. Marques, Idalina Domingos, Helena Pereira. Wood Science and Technology, 2007

318 citations recorded by the source corpus.

Subfields: Building and Construction, Mechanical Engineering, Organic Chemistry

View Paper: https://www.semanticscholar.org/paper/51365ffa25ec0d6d8aa94b560af35a98120268a8

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Building and Construction

In Mechanical Engineering

In Organic Chemistry

Citations in the corpus

Wood modification by heat treatment: a review. (2009, background): “Esteves et al. (2007b) reported a higher mass loss for a hardwood (Eucalyptus globulus) than for a softwood species (Pinus pinaster) under the same treatment conditions.”
Future Perspectives of Biomass Torrefaction: Review of the Current State-Of-The-Art and Research Development (2018, background): “biomass depends on the duration of heating and the maximum temperature obtained [40].”
Effect of processing methods on the mechanical properties of engineered bamboo (2015, unknown): “properties [12–19].”
Colour in thermally modified wood of beech, Norway spruce and Scots pine. Part 1: Colour evolution and colour changes (2009, background): “62) was later determined for Pinus pinaster Aiton (Esteves et al. 2007).”
Effect of thermal treatment on the physical and mechanical properties of phyllostachys pubescen bamboo (2012, background): “…Behandlung auf die physikalischen und mechanischen Eigenschaften von Phyllostachys pubescen Bambus Zusammenfassung Phyllostachys pubescen Bambus wurde in einem Trocknungsofen bei sieben Temperaturstufen (100 bis 220 C) und vier unterschiedlichen Behandlungszeiten (1–4 h) thermisch behandelt.”
Extractive composition and summative chemical analysis of thermally treated eucalypt wood (2008, methodology): “Samples (40 mm3) were prepared by two different methods, which are based on an autoclave steam heat treatment and an oven heating in air as reported by Esteves et al. (2007b).”
Chemical changes of heat treated pine and eucalypt wood monitored by FTIR (2013, background): “…2007a, Esteves et al. 2007b, Esteves et al. 2008a), increase its dimensional stability (Viitaniemi et al. 1997, Yildiz 2002, Wang and Cooper 2005, Esteves et al. 2007a, Esteves et al. 2007b), and increase its durability (Dirol and Guyonnet 1993, Kamdem et al. 2002) and its darkness (Mitsui et…”
PINE WOOD MODIFICATION BY HEAT TREATMENT IN AIR (2008, result): “Similar results for the degradation rate were also reported for the heat treatment of other species like cedar (González-Peña et al. 2004).”