Hole quality assessment following drilling of metallic-composite stacks

By Islam Shyha, S. Soo, D. Aspinwall, S. Bradley, R. Perry, P. Harden, Stuart Dawson. 2011

225 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/f06494376c4c9fab6803d541f4da5ff2f02d834a

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

1. I. S. Jawahir
2. Mohamed El Mansori
3. Jinyang Xu
4. Y. Kaynak

In Electrical and Electronic Engineering

1. Y. Kaynak
2. I. S. Jawahir
3. Mohamed El Mansori
4. Jinyang Xu
5. Ali Mkaddem

In Mechanical Engineering

1. Y. Kaynak
2. I. S. Jawahir
3. Mohamed El Mansori
4. Tian Xia
5. C. Arvin
6. Ali Mkaddem
7. Jinyang Xu

Citations in the corpus

• Cryogenic cooling-induced process performance and surface integrity in drilling CFRP composite material (2016, background): “As similar trends were reported in the literature, it was shown that oversized holes produced in drilling CFRP composite material is most likely due to the thermal expansion of the matrix from increased cutting temperatures caused by the lack of lubricant/coolant access and poor chip evacuation [16]”
• Experimental study on drilling mechanisms and strategies of hybrid CFRP/Ti stacks (2016, unknown): “Previous studies [11,12,21] have shown that the hole quality is greatly affected by input cutting variables (cutting speed and feed rate) when drilling hybrid composite stacks.”
• Recent advances in drilling hybrid FRP/Ti composite: A state-of-the-art review (2016, methodology): “Besides, some other researchers [50,92] pointed out that the use of fresh tool and superior tool material (e.”