Experimental and numerical investigation of the effect of spray cutting fluids in high speed milling

By L. N. L. Lacalle, C. Angulo, A. Lamikiz, J. A. Sánchez. 2006

258 citations recorded by the source corpus.

Subfields: Mechanical Engineering, Plant Science

View Paper: https://www.semanticscholar.org/paper/483ce24495be8c0b6623b9aa958434b828526cb5

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Mechanical Engineering

1. Ahmed A. D. Sarhan
2. Imtiaz Ahmed Choudhury
3. Peihua Yan
4. G. Wang
5. S. A. Lawal
6. M. Emami
7. Yusoff Nukman
8. F. Hasani

In Plant Science

1. Ahmed A. D. Sarhan
2. M. Emami
3. F. Hasani
4. M. Sadeghi

Citations in the corpus

• A critical assessment of lubrication techniques in machining processes: a case for minimum quantity lubrication using vegetable oil-based lubricant (2013, background): “Lopezde Lacalle et al., (2000) observed that under high pressure jet turning of titanium, there was a reduction in cutting force and tool tip temperature.”
• The effect of cutting fluids applied in metal cutting process (2016, background): “In high-speed milling, conventional emulsion coolant was inefficient as it could not reach the cutting zone, whereas minimum quantity lubrication (MQL) flow could penetrate into the cutting zone, and the nozzle position and feed direction were very important.(22) MQL could enhance the penetration by”
• Investigating the Minimum Quantity Lubrication in grinding of Al2O3 engineering ceramic (2014, background): “As well as reducing the amount of cutting fluids during machining, MQL can also provide efficient lubrication (Emami et al., 2013; López de Lacalle et al., 2006).”