Microstrip filters for RF/microwave applications

By Jiasheng Hong. 2001

6,007 citations recorded by the source corpus.

Subfields: Electrical and Electronic Engineering

View Paper: https://www.semanticscholar.org/paper/27c42940587d12477fbba5e9a046df353e5da11d

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Electrical and Electronic Engineering

1. Ke Wu
2. Lei Zhu
3. Ferran Martín
4. Xiaoping Chen
5. Tatsuo Itoh
6. Wen Wu
7. Chunxia Zhou
8. K. Zhou

Citations in the corpus

• Transmission Lines Loaded With Bisymmetric Resonators and Their Application to Angular Displacement and Velocity Sensors (2013, methodology): “The lumped element values are pF, nH, pF, nH, and nH. lossless electromagnetic simulation (using Agilent Momentum commercial software) are plotted in Fig.”
• Half Mode Substrate Integrated Waveguide (HMSIW) Bandpass Filter (2007, background): “can be evaluated by the formula [10], which is mainly affected by the transition between micrstrip and HMSIW.”
• Transmission Lines Loaded With Pairs of Stepped Impedance Resonators: Modeling and Application to Differential Permittivity Measurements (2016, methodology): “Nevertheless, a method to estimate the loss factor is included in the last section.”
• Resonance Characteristics of Substrate-Integrated Rectangular Cavity and Their Applications to Dual-Band and Wide-Stopband Bandpass Filters Design (2017, methodology): “Qe and Q II e , respectively, representing the Qe in the first and second passbands, can then be extracted from the phase and group delay responses of S11 using the formula [34]”
• Varactor-Tuned Dual-Mode Bandpass Filters (2010, background): “B. Ideal Requirement for Tunable Dual-Mode Filter To tune the center frequency of this type of dual-mode filter while keeping constant filter response shape and bandwidth, two factors ideally need to be considered.”
• Development of Millimeter-Wave Planar Diplexers Based on Complementary Characters of Dual-Mode Substrate Integrated Waveguide Filters With Circular and Elliptic Cavities (2007, background): “The diplexers are then designed with the complementary characters, which results in in-band low insertion loss and out-band rapid falloff characteristics, where the tradeoff between the insertion loss, selectivity, and isolation are made for high-performance requirement.”
• An optimum ultra‐wideband microstrip filter (2005, background): “As an alternative, tabulated elements can be found in [8] for this type of filter, which is also seen as the optimum pseudo-highpass filter.”
• A Differential-Mode Wideband Bandpass Filter on Microstrip Line for UWB Application (2009, methodology): “1(b) again, this two-port bisection with shunt short-circuited stubs are exactly the same as the highpass filter [11] or ultra-wideband BPFs originated in [5], [6].”
• Low-power microwave plasma source based on a microstrip split-ring resonator (2003, methodology): “the quasi-static approximation [13], [14] and then refined by finite-element analysis.”
• Synthesis Method for Even-Order Symmetrical Chebyshev Bandpass Filters With Alternative $J/K$ Inverters and /spl lambda//4 Resonators (2013, methodology): “Thus, an additional impedance transformer needs to be installed at the output port if the synthesis method in [1] is applied to design this even-order filter with a Chebyshev frequency response.”
• Stopband-Extended Balanced Bandpass Filter Using Coupled Stepped-Impedance Resonators (2007, methodology): “calculated from [8] may be expressed as Fig.”