An experimental investigation of effects of cooling/lubrication conditions on tool wear in high-speed end milling of Ti-6Al-4V

By Yongsheng Su, N. He, Liang Li, Xin Li. 2006

285 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/19cda90fd0fc1c56144c8e444ac949c68805bc56

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

1. Guy Littlefair
2. A. Pramanik
3. Kapil Kumar Gupta
4. R. Laubscher

In Electrical and Electronic Engineering

1. Guy Littlefair
2. A. Pramanik
3. Kapil Kumar Gupta
4. R. Laubscher

In Mechanical Engineering

1. Guy Littlefair
2. A. Pramanik
3. Kapil Kumar Gupta
4. R. Laubscher

Citations in the corpus

• Machining of Titanium Alloy (Ti-6Al-4V)—Theory to Application (2015, methodology): “(Su et al., 2006) Cutting tool: Walter ZDGT150420R, TiN /TiC/ TiN coated carbide, one tooth Speed: 400 Feed: 0.1 Axial depth of cut: 5.0 Radial depth of cut: 1.0 Case 1: Dry; case 2: flood coolant; case 3: nitrogen-oil-mist; case 4: compressed cold nitrogen gas (0, −10◦C); case 5: compressed cold…”
• Sustainable machining of titanium alloys: A critical review (2017, methodology): “During high-speed end milling of Ti-6Al-4V, significant improvement in tool life was observed by Su et al.(66) while employing compressed cold nitrogen gas and oil mist (called as CCNGOM) as the cooling/lubrication condition.”
• SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS (2009, unknown): “, 1993) and high chemical reactivity (Su et al., 2006).”
• Machining Ti–6Al–4V alloy with cryogenic compressed air cooling (2010, unknown): “Considering the negative impact of liquid coolant on the environment and operator health, alternative environmentally friendly solutions such as gaseous lubricants have been developed, including oxygen, carbon dioxide, gaseous and liquid nitrogen gas [22–24], water vapour [25,26] and cold air genera”
• A comparative study of the cutting forces in high speed machining of Ti–6Al–4V and Inconel 718 with a round cutting edge tool (2009, unknown): “The vast majority of the published literature focuses on either Ti–6Al–4V (Su et al., 2006; Molinari et al., 2002; Baker et al., 2002; Komanduri and Hou, 2002; Barry et al., 2001; Bayoumi and Xie, 1995) or Inconel 718 (Nalbant et al.”