Inertia effects in uniaxial dynamic compression of a closed cell aluminium alloy foam

By P. Tan, J. Harrigan, S. Reid. 2002

215 citations recorded by the source corpus.

Subfields: Materials Chemistry, Mechanical Engineering, Pulmonary and Respiratory Medicine

View Paper: https://www.semanticscholar.org/paper/12e298e555f45e890ab15e7e71cf72ca7486b48e

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Materials Chemistry

1. V. Deshpande
2. Norman A. Fleck
3. Qingming Li
4. J. Harrigan
5. Han Zhao
6. I. Elnasri
7. I. Magkiriadis
8. D. Radford

In Mechanical Engineering

1. V. Deshpande
2. Norman A. Fleck
3. D. Radford
4. Qingming Li
5. H. Wadley
6. J. Harrigan
7. Han Zhao
8. I. Elnasri

In Pulmonary and Respiratory Medicine

1. Qingming Li
2. V. Deshpande
3. Norman A. Fleck
4. I. Magkiriadis
5. J. Harrigan
6. D. Radford
7. François Hild

Citations in the corpus

• One-dimensional response of sandwich plates to underwater shock loading (2005, result): “Thus, this model is analogous to the rigid–plastic-locking models for the dynamic compression of foams presented by Ashby et al. (2000) and Tan et al. (2002).”
• Shock enhancement of cellular structures under impact loading: Part II analysis (2007, background): “Afterwards, a number of authors also reported this effect for various cellular materials at high impact speeds (Lopatnikov et al., 2003; 2004; Tan et al. 2002, 2005; Rodford et al., 2005).”
• Dynamic compressive behaviour of cellular materials: A review of phenomenon, mechanism and modelling (2018, unknown): “[54, 101] studied the dynamic compressive strength of closed-cell aluminium Hydro/Cymat foams using direct impact experimental setups with impact velocity ranging from 10 to 210 m/s, and they observed an approximately quadratic increase in dynamic plateau stress with impact velocity.”
• Compressive Strain at the Onset of Densification of Cellular Solids (2006, methodology): “The energy absorption efficiency to determine a representative strain of densification is used in [4], i.”
• The use of metal foam projectiles to simulate shock loading on a structure (2005, background): “[3] has revealed that metal foams collapse at almost constant pressures; the magnitude of this pressure increases from a few MPa at quasistatic loading rates to a pressure on the order of hundreds of MPa when the loading speed is increased to a few hundred metres per second due to the propagation of”
• Shock enhancement of cellular structures under impact loading: Part I Experiments (2007, background): “Tan et al. (2002, 2005) reported shock effect on Cymat foam and they believed that there exists a critical velocity (44 m / s to 108 m / s) under which such shock effect is not significant.”