Tool life and surface integrity in turning titanium alloy

By C. H. Che-Haron. 2001

344 citations recorded by the source corpus.

Subfields: Materials Chemistry, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/0f9605afc6616612f4631ceba7048b8bdc10a980

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Materials Chemistry

1. S. Niketh
2. G. Samuel
3. A. Jawaid
4. Mihai Nicolescu
5. S. Pervaiz
6. Amir Rashid
7. Ibrahim M. Deiab

In Mechanical Engineering

1. Ibrahim M. Deiab
2. S. Pervaiz
3. Mihai Nicolescu
4. Amir Rashid
5. G. Samuel
6. S. Niketh
7. A. Jawaid
8. Ulas Çaydas

Citations in the corpus

• The effect of machining on surface integrity of titanium alloy Ti–6% Al–4% V (2005, background): “Titanium alloy Ti–6% Al–4% V is a widely used titanium alloy and offers high strength, depth hardenability and elevated temperature properties up to 400 ◦C. The mechanical properties of tested material are shown in Table 2 [ 8 ].”
• Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review (2014, background): “Based on the fact that higher cutting speed results in high cutting temperature at tool tip, excessive stresses are formed to plastically deform tool tip [88].”
• Surface texturing for tribology enhancement and its application on drill tool for the sustainable machining of titanium alloy (2017, background): “…of this material results in high heat generation during machining processes, which leads to rapid tool failure (Yang and Richard Liu, 1999) (Che-Haron (2001)). studied about the metallurgical and microhardness changes while machining titanium alloys and described its effect in surface…”