Effects and mechanisms in minimal quantity lubrication machining of an aluminum alloy

By F. Itoigawa, T. Childs, Takashi Nakamura, W. Belluco. 2006

206 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/0e856a038677e3992472f9ff062729f69d0790c1

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. M.M.A. Khan
2. Nikhil Ranjan Dhar
3. GurRaj Singh
4. Vishal S. Sharma
5. Knut Sørby

In Electrical and Electronic Engineering

1. M.M.A. Khan
2. Nikhil Ranjan Dhar
3. Imtiaz Ahmed Choudhury
4. S. A. Lawal
5. Yusoff Nukman

In Mechanical Engineering

1. M.M.A. Khan
2. Hsiu-Hsia Lin
3. Y. Liao
4. Nikhil Ranjan Dhar
5. Y. Chen
6. Imtiaz Ahmed Choudhury
7. S. A. Lawal
8. Yusoff Nukman

Citations in the corpus

• Feasibility study of the minimum quantity lubrication in high-speed end milling of NAK80 hardened steel by coated carbide tool (2007, background): “It was revealed that MQL could be widely utilized in the machining of aluminum and aluminum alloys [9–12].”
• Performance evaluation of minimum quantity lubrication by vegetable oil in terms of cutting force, cutting zone temperature, tool wear, job dimension and surface finish in turning AISI-1060 steel (2006, background): “In actual conditions with high machining load, however, existence of this kind of boundary film is uncertain ( Itoigawa et al., 2005 ).”