Multimodal Energy Harvesting System: Piezoelectric and Electromagnetic

By Yonas T. Tadesse, Shujun Zhang, Shashank Priya. 2009

249 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/fb197023a4a353e03996eb1b7d105a04eddc579e

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. Lihua Tang
2. Yaowen Yang
3. Chee Kiong Soh
4. Hao Wu
5. S. Anton
6. Mohsen Safaei
7. Fabio Semperlotti
8. S. Conlon

In Electrical and Electronic Engineering

1. Lihua Tang
2. Yaowen Yang
3. Chee Kiong Soh
4. Mohsen Safaei
5. S. Anton
6. Hao Wu
7. Henry Sodano
8. Sanjib Kumar Panda

In Mechanical Engineering

1. Lihua Tang
2. Yaowen Yang
3. Chee Kiong Soh
4. Mohsen Safaei
5. S. Anton
6. Hao Wu
7. Henry Sodano
8. Sanjib Kumar Panda

Citations in the corpus

• Toward Broadband Vibration-based Energy Harvesting (2010, methodology): “One example is the design of a multimodal energy harvester presented by Tadesse et al. (2009), as shown in Figure 28.”
• A multiple-degree-of-freedom piezoelectric energy harvesting model (2012, unknown): “Tadesse et al. (2009) presented a cantilever harvester integrated with hybrid energy harvesting schemes, each of which is efficient for a specific mode.”
• Broadband energy harvesting using acoustic black hole structural tailoring (2014, background): “Interest in extending the frequency performance of the harvesters as well as reducing the dependence on the driving frequency has led to investigations of multimodal [7] and tunable [8, 9] devices and, later on, nonlinear mechanisms.”
• Energy Harvesting From Hybrid Indoor Ambient Light and Thermal Energy Sources for Enhanced Performance of Wireless Sensor Nodes (2011, background): “The concept of HEH has been recently discussed in the literature [12]–[16] as a potential micro-power supply solution to minimize the size of the energy supply as well as to extend the operational lifetime of the wireless sensor node.”
• A review of energy harvesting using piezoelectric materials: state-of-the-art a decade later (2008–2018) (2019, methodology): “A similar design was proposed by Tadesse et al in 2009 [458], in which PZN-PT crystals were attached to a cantilever beam with a tip magnet and a stationary coil (figure 18(d)).”
• Investigation of Multimodal Electret-Based MEMS Energy Harvester With Impact-Induced Nonlinearity (2018, unknown): “Various 2DOF harvesters have been developed, including 2DOF cut-out beam structures [5], L-shaped beam configurations [6], 2DOF electromagnetic-piezoelectric hybrid structures [7], dual-mass cantilever beam [8], dual-beam system [9], [10] and dynamic amplifier system [11].”
• Development of a broadband nonlinear two-degree-of-freedom piezoelectric energy harvester (2014, background): “…harvester with conventional cantilever configuration can also provide multiple resonances; however, its highorder vibration modes are usually separated very far away from the fundamental one with much smaller amplitude (Tadesse et al. 2009; Erturk et al.2009b; Ou et al., 2012; Tang and Yang, 2012).”