Piezoelectric Energy Harvesting with a Clamped Circular Plate: Analysis
By Sunghwan Kim, W. Clark, Qing-Ming Wang. 2005
234 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/f820d8d590a419663e77572e2c20c494f79e1c41
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
In Electrical and Electronic Engineering
In Mechanical Engineering
Citations in the corpus
- Piezoelectric Energy Harvesting with a Clamped Circular Plate: Experimental Study (2005, methodology): “A companion article (Kim et al., 2005) analyzed the effect of geometric factors and electrode patterns on the performance of a piezoelectric plate as an energy harvesting mechanism.”
- A coupled piezoelectric–electromagnetic energy harvesting technique for achieving increased power output through damping matching (2009, methodology): “Other designs include a non-uniform thickness piezoelectric cantilever beam [17], and a clamped circular plate geometry [18, 19].”
- A review of power harvesting using piezoelectric materials (2003–2006) (2007, unknown): “In a subsequent study by Kim et al (2005b), the analytical results of altering the electrode pattern were tested experimentally, and it was found that a plate with part of the electrode surface repoled to provide reverse polarity from the unmodified section produced the greatest power output.”
- Design of Piezoelectric Energy Harvesting Systems: A Topology Optimization Approach Based on Multilayer Plates and Shells (2009, background): “The first problem is a cantilever beam harvester (Erturk and Inman, 2008b, c, 2009; Erturk et al., 2009) and the second problem a piezoelectric circular plate (Kim et al., 2005a, b).”
- Analysis of power output for piezoelectric energy harvesting systems (2006, unknown): “Instead of 1-D design, Kim et al [16, 17] and Ericka et al [8] have modeled and designed piezoelectric plates (membranes) to harvest energy from pulsing pressure sources.”
- Revisit of series-SSHI with comparisons to other interfacing circuits in piezoelectric energy harvesting (2010, unknown): “The layout of electrodes on the plate’s surfaces has to be carefully patterned to avoid charge cancellation [18, 41].”
- Energy harvesting vibration sources for microsystems applications (2006, methodology): “Energy harvesting using circular piezoelectric plates bonded to a clamped circular substrate has also been studied by Kim et al [78, 79].”
- An improved analysis of the SSHI interface in piezoelectric energy harvesting (2007, background): “As a result, piezoelectric elements for scavenging energy from ambient vibration sources have been used in various types of structures to serve specific purposes, including the use of resonant piezoelectric-based structures of cantilever beam configuration [1, 11, 14, 23, 40, 51, 54] as well as plat”
- Powering MEMS portable devices—a review of non-regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting systems (2008, background): “one group fabricated clamped short discs for piezoelectric energy harvesting [242, 243] and concluded that the ratio of layer thickness (piezoelectric layer to substrate layer) and”
- Model of a single mode energy harvester and properties for optimal power generation (2008, methodology): “Additionally, because piezoelectric materials generate both positive and negative voltages dependent on the strain direction, harvesting energy from higher order modes is difficult without a segmented electrode, due to charge cancelation [18].”