Effects of Decalcification on the Microstructure and Surface Area of Cement and Tricalcium Silicate Pastes | NIST
By Jeffrey J. Thomas, Jeffrey J. Chen, H. Jennings, A. Allen. 2004
141 citations recorded by the source corpus.
Subfields: Civil and Structural Engineering, Materials Chemistry
View Paper: https://www.semanticscholar.org/paper/efef3dbb6e56b96329c821ce9b5f906a4f11080a
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Civil and Structural Engineering
- Franz-Josef Ulm
- Jeffrey J. Thomas
- Georgios Constantinides
- H. Jennings
- Jeffrey J. Chen
- Julia S. Gevrenov
- M. Vandamme
- Zongjin Li
In Materials Chemistry
- Franz-Josef Ulm
- Georgios Constantinides
- Jeffrey J. Thomas
- H. Jennings
- Jeffrey J. Chen
- Zongjin Li
- Chuanlin Hu
- M. Vandamme
Citations in the corpus
- Decalcification shrinkage of cement paste (2006, methodology): “Small-angle neutron scattering (SANS) measurements showed [20] a near doubling of the specific surface area when C3S or cement paste was decalcified from the original Ca/Si ratio of 3 down to Ca/Si=1.1.”
- Effect of limestone fillers on microstructure and permeability due to carbonation of cement pastes under controlled CO2 pressure conditions (2015, unknown): “Consequently, the specific surface area is expected to increase [48].”
- A multi-technique investigation of the nanoporosity of cement paste (2007, methodology): “However, the SANS response from cement paste does not exhibit any of the hallmarks of elongated or sheetlike particles, unless the C-S-H phase is decalcified [3].”