Investigation of electro-discharge micro-machining of titanium super alloy
By B. B. Pradhan, M. Masanta, B. Sarkar, Bijoy Bhattacharyya. 2009
181 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/ed747595663e52f6be957e1919d453fd1c2003a8
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- Oguzhan Yilmaz
- M. A. Okka
- Edmundas Kazimieras Zavadskas
- Shankar Chakraborty
- B. Sarkar
- Golam Kibria
- Bijoy Bhattacharyya
- B. B. Pradhan
In Electrical and Electronic Engineering
- Oguzhan Yilmaz
- M. A. Okka
- Edmundas Kazimieras Zavadskas
- Shankar Chakraborty
- B. Sarkar
- Golam Kibria
- Bijoy Bhattacharyya
- B. B. Pradhan
In Mechanical Engineering
- Edmundas Kazimieras Zavadskas
- Shankar Chakraborty
- Oguzhan Yilmaz
- M. A. Okka
- B. Sarkar
- Golam Kibria
- Bijoy Bhattacharyya
- B. B. Pradhan
Citations in the corpus
- INVESTIGATING THE EFFECTS OF EDM PARAMETERS ON SURFACE INTEGRITY, MRR AND TWR IN MACHINING OF Ti–6Al–4V (2012, background): “( 2009 ) attempted to optimize micro-EDM process parameters for machining Ti-6Al-4V alloy.”
- Effect of single and multi-channel electrodes application on EDM fast hole drilling performance (2010, methodology): “In order to optimize performance characteristics of EDM of titanium-based alloys, Kao et al. [11 ]s howed an improvement 15% on EWR, 12% on MRR, and 19% on SR. Similarly, another optimization attempt was carried out by Paradhan et al. [ 12 ] using ANOVA and S/N ratio graphs on EDM hole drilling of T”
- Comparative study of different dielectrics for micro-EDM performance during microhole machining of Ti-6Al-4V alloy (2010, background): “As the micro-EDM performances are affected mostly by peak current (Ip) and pulse-on-time (Ton) during machining of Ti-6Al-4V alloy [14, 15 ], so influence of these two predominant process parameters were considered as the varying parameters keeping other process parameters like flushing pressure (P”
- Applications of WASPAS Method in Manufacturing Decision Making (2014, methodology): “These parametric combinations almost corroborate with the observations derived by Pradhan et al. (2009) while employing Taguchi technique.”