An optimized self-powered switching circuit for non-linear energy harvesting with low voltage output

By Mickaël Lallart, Daniel Guyomar. 2008

284 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/ea9be91f1b03676bd43d41e2590738cdc6230870

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. S. Anton
2. Wei-Hsin Liao
3. Dong Sam Ha
4. Junrui Liang
5. Na Kong
6. Daniel J. Inman
7. Mickaël Lallart
8. S. Burrow

In Electrical and Electronic Engineering

1. S. Anton
2. Daniel J. Inman
3. Wei-Hsin Liao
4. Junrui Liang
5. Mickaël Lallart
6. S. Burrow
7. Dong Sam Ha
8. Na Kong

In Mechanical Engineering

1. S. Anton
2. Daniel J. Inman
3. Dong Sam Ha
4. Wei-Hsin Liao
5. Na Kong
6. Junrui Liang
7. Mickaël Lallart
8. S. Burrow

Citations in the corpus

• Frequency Self-tuning Scheme for Broadband Vibration Energy Harvesting (2010, methodology): “For the sake of simplicity, the harvesting circuitry considered here will be made only of a bridge rectifier connected to a smoothing capacitance CS and a load RL (Figure 1), although more efficient energy interfaces can be considered (Badel et al., 2005; Guyomar et al., 2005, 2009; Lefeuvre et al.,”
• An Efficient Piezoelectric Energy Harvesting Interface Circuit Using a Bias-Flip Rectifier and Shared Inductor (2009, unknown): “6X improvement [16] in output power extracted compared to conventional full-bridge rectifiers.”
• Impedance Modeling and Analysis for Piezoelectric Energy Harvesting Systems (2012, result): “Previous studies on P-SSHI and S-SSHI were mostly conducted under constant displacement excitation [24], [45].”
• Experimental Duffing oscillator for broadband piezoelectric energy harvesting (2011, background): “The power electronics and control strategies may be inspired from previous energy harvesting developments, such as [3, 4] for power management, and such as [27, 28] for low energy control systems.”
• Revisit of series-SSHI with comparisons to other interfacing circuits in piezoelectric energy harvesting (2010, unknown): “This technique was proposed by Guyomar and his co-workers [2, 12, 19, 21, 29] who have shown that power is boosted significantly in a weakly coupled electromechanical system.”
• Low-Power Design of a Self-powered Piezoelectric Energy Harvesting System With Maximum Power Point Tracking (2012, background): “However, since MOSFETs should be switched synchronously with the displacement of the cantilever beam, it is challenging to realize stringent timing control with reasonably low circuit complexity and low power consumption [15], [16].”
• Review of Power Conditioning for Kinetic Energy Harvesting Systems (2012, methodology): “In practical implementations of these circuits, the voltage inversion and therefore the maximum power yield of the generator is limited by the series resistance of the inductor and the voltage drops across the switching devices [64].”
• Array of piezoelectric energy harvesting by the equivalent impedance approach (2012, unknown): “While the analysis of these interface circuits in the case of a single piezoelectric oscillator has been studied in several research works [1, 10, 15, 17, 18, 24, 25, 33, 37–39, 41], the extension to the case of multiple piezoelectric oscillators has not been done yet.”