Surface plasmon resonance sensor based on a single-mode polarization-maintaining optical fiber

By M. Piliarik, Jiri Homola, Z. Maníková, J. Čtyroký. 2003

246 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering

View Paper: https://www.semanticscholar.org/paper/e96890309cb941a47020265d74d4b8e1b1bed1d0

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. A. Rifat
2. Rajib Ahmed
3. Banshi D. Gupta
4. F. Adikan
5. Rajneesh Kumar Verma
6. Anuj Kumar Sharma
7. R. Jha
8. S. Yun

In Electrical and Electronic Engineering

1. A. Rifat
2. Rajib Ahmed
3. F. Adikan
4. Banshi D. Gupta
5. Rajneesh Kumar Verma
6. Anuj Kumar Sharma
7. R. Jha
8. S. Yun

Citations in the corpus

• Fiber-Optic Sensors Based on Surface Plasmon Resonance: A Comprehensive Review (2007, background): “The use of single-mode polarization maintaining fiber (PMF) for SPR sensors was another milestone [40].”
• Surface Plasmon Resonance-Based Fiber Optic Sensors: Principle, Probe Designs, and Some Applications (2009, background): “Due to these advantages the surface plasmon resonance-based optical fiber sensors have drawn a lot of attention [10–23].”
• Highly Sensitive D-Shaped Photonic Crystal Fiber-Based Plasmonic Biosensor in Visible to Near-IR (2017, result): “17×10−6 RIU (without considering any practical noise influence; and assuming minimum 1% transmitted intensity could be detected); which indicates capability of the sensor in detecting very small RI changes in the order of 10−6, which is better compared to the results reported in [5], [36], and [37].”
• Low Cost Sensors Based on SPR in a Plastic Optical Fiber for Biosensor Implementation (2011, background): “The advantages of POF sensors is that they are simpler to manufacture than those using silica optical fibers [1,3].”
• Surface Plasmon Resonance for Biosensing: A Mini-Review (2008, methodology): “SPR-based sensors using polarization-maintaining fibers have been also used (Piliarik et al., 2003).”
• Graphene Enhances the Sensitivity of Fiber-Optic Surface Plasmon Resonance Biosensor (2015, unknown): “biosensors [4]–[7].”
• Dielectric-Grating-Coupled Surface Plasmon Resonance From the Back Side of the Metal Film for Ultrasensitive Sensing (2016, methodology): “However, most of these designs are limited by the difficult nanofabrication on fiber side walls [12], [13] or fiber tips [14], [15].”
• Photonic crystal fiber based plasmonic sensors (2017, methodology): “Transmission method is widely used for fiber based SPR sensors, where the plasmonic metal layer or nanoparticles is placed in an etched cladding region [35-38, 61-64].”