The thermal effects on electrospinning of polylactic acid melts

By Huajun Zhou, T. B. Green, Y. Joo. 2006

366 citations recorded by the source corpus.

Subfields: Biomaterials, Biomedical Engineering

View Paper: https://www.semanticscholar.org/paper/e5f77611f73ec0a5ccd0d80ed4c41461f5507f8a

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomaterials

1. Tong Lin
2. Xungai Wang
3. J. Fang
4. R. Padhye
5. R. Nayak
6. Lyndon Arnold
7. I. L. Kyratzis
8. Y. Truong

In Biomedical Engineering

1. Tong Lin
2. J. Fang
3. Xungai Wang
4. Lyndon Arnold
5. R. Padhye
6. R. Nayak
7. I. L. Kyratzis
8. Y. Truong

Citations in the corpus

• Electrospinning of polymer melts: Phenomenological observations (2007, background): “However, recent melt electrospinning publications demonstrate that continuous fibers of approximately one micron in diameter are possible, and therefore provide the benefits of nanometer diameter fibers often produced with solution electrospinning [8, 10 ,11].”
• Needleless melt-electrospinning of polypropylene nanofibres (2012, background): “Most previous research into melt-electrospinning has observed a decreased fibre diameter with increasing applied voltage [22, 29, 33], normally attributed to the higher stretching force from the increased electric field intensity.”
• Structural and Morphological Characterization of Micro and Nanofibers Produced by Electrospinning and Solution Blow Spinning: A Comparative Study (2013, background): “On the other hand, solution blow spun and electrospun PLA fibers clearly exhibited two reflection peaks (near 13 and 16), ascribed to α crystals, and a small peak (near 24) associated with β phase [38, 39].”
• Polylactic acid (PLA)/halloysite nanotube (HNT) composite mats: Influence of HNT content and modification (2015, methodology): “The degree of crystallinity (Xc) was calculated as [26, 27]”
• Recent advances in nanofibre fabrication techniques (2012, background): “Melt electrospinning has several advantages over solution electrospinning such as no recycling/removal of toxic solvents, high throughput rate as there is no loss of mass by solvent evaporation, ease of fabricating polymeric fibre blends and suitability to the polymers (such as PE, PP and PET) havin”