Material behaviour in metal cutting: strains, strain rates and temperatures in chip formation

By S. Jaspers, J. H. Dautzenberg. 2002

184 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Civil and Structural Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/e4e6caecae747fb10d50ee8c07d4426078bec09a

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. Yigit Karpat
2. Liangchi Zhang
3. A. Pramanik
4. J. A. Arsecularatne
5. Tugrul Özel
6. V. Gaitonde
7. Mohammad Robiul Hossan
8. L. Qian

In Civil and Structural Engineering

1. Yigit Karpat
2. J. A. Arsecularatne
3. A. Pramanik
4. Liangchi Zhang
5. Tugrul Özel
6. É. Rivière-Lorphèvre
7. François Ducobu
8. Enrico Filippi

In Mechanical Engineering

1. Yigit Karpat
2. A. Pramanik
3. Liangchi Zhang
4. J. A. Arsecularatne
5. Tugrul Özel
6. N. Muthukrishnan
7. V. Gaitonde
8. Mohammad Robiul Hossan

Citations in the corpus

• Machining of metal matrix composites: effect of ceramic particles on residual stress, surface roughness and chip formation (2008, background): “, those experienced during turning [22-24], the strength is considerably dependent on strain rate and it increases with the increase of strain rate [25-27].”
• Identification of Constitutive Material Model Parameters for High-Strain Rate Metal Cutting Conditions Using Evolutionary Computational Algorithms (2007, background): “For instance, while the strain rates around 105 s−1 can be obtained by SHPB compression tests, average strain rates around 20,000s−1 are seen in the shearing zone during actual high-speed cutting [5].”
• An FEM investigation into the behavior of metal matrix composites: tool-particle interaction during orthogonal cutting (2007, methodology): “The damage of the tool cutting edge/flank was attributed to abrasion [23,25,28,29] and pull out of tool material grains from cutting edge and”