Comparison of ASTM saturation techniques for measuring the permeable porosity of concrete

By Mohammed Safiuddin, N. Hearn. 2005

203 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering

View Paper: https://www.semanticscholar.org/paper/e10a301fa00b2e9961d8aaa3cd1fa2f8076f11a3

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

1. H. Brouwers
2. P. Spiesz
3. R. Yu
4. Q. Yu
5. G. Quercia
6. G. Hüsken
7. A. Szczotok
8. A. Kjøniksen

Citations in the corpus

• Mix design and properties assessment of Ultra-High-Performance Fibre Reinforced Concrete (UHPFRC) (2014, methodology): “For instance, Safiuddin and Hearn [37] reported a porosity of 20.5% for concrete produced with a water/cement ratio of 0.60, employing the same measurement method (vacuum-saturation technique).”
• Effect of nano-silica on the hydration and microstructure development of Ultra-High Performance Concrete (UHPC) with a low binder amount (2014, unknown): “The porosity of the hardened UHPC is measured applying the vacuum-saturation technique, which is referred to as the most efficient saturation method [32].”
• SCC modification by use of amorphous nano-silica (2014, methodology): “The vacuum-saturation technique was applied to fill the accessible pores with water, as this technique is concluded to be the most efficient by Safiuddin and Heran [43].”
• Microencapsulated phase change materials for enhancing the thermal performance of Portland cement concrete and geopolymer concrete for passive building applications (2017, methodology): “The porosity test was done based on ASTM C1202-12, which has been used by other researchers [27,28].”
• Development of cement-based lightweight composites : part 1: mix design methodology and hardened properties (2013, methodology): “It can be seen that all the obtained values are larger compared to conventional concrete, for instance [41] reported a porosity of 20.”
• A study of multiple effects of nano-silica and hybrid fibres on the properties of Ultra-High Performance Fibre Reinforced Concrete (UHPFRC) incorporating waste bottom ash (WBA) (2014, unknown): “The porosity of the designed UHPFRC is measured applying the vacuum-saturation technique, which is referred to as the most efficient saturation method [48].”
• Development of an eco-friendly Ultra-High Performance Concrete (UHPC) with efficient cement and mineral admixtures uses (2015, methodology): “For instance, Safiuddin and Hearn [52] reported a porosity of 20.”