Finite element simulation of conventional and high speed machining of Ti6Al4V alloy
By Domenico Umbrello. 2008
415 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Materials Chemistry, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/dfa5a8e35ecacb1becc2dd20b0684f16233e7d11
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- É. Rivière-Lorphèvre
- X. Jin
- Tao Guo
- François Ducobu
- Xiaoyong Yang
- Enrico Filippi
- Guangsi Chen
- F. Girot
In Materials Chemistry
- É. Rivière-Lorphèvre
- X. Jin
- Tao Guo
- François Ducobu
- Xiaoyong Yang
- Enrico Filippi
- Guangsi Chen
- F. Girot
In Mechanical Engineering
- É. Rivière-Lorphèvre
- X. Jin
- Tao Guo
- François Ducobu
- Xiaoyong Yang
- Enrico Filippi
- Guangsi Chen
- F. Girot
Citations in the corpus
- On the importance of the choice of the parameters of the Johnson-Cook constitutive model and their influence on the results of a Ti6Al4V orthogonal cutting model (2017, methodology): “According to Umbrello et al. [17,18], the Johnson-Cook flow stress is not suited for large strains due to its identification with SPHB that cannot reach strains as large as in machining.”
- Temperature dependent flow softening of titanium alloy Ti6Al4V: An investigation using finite element simulation of machining (2011, neutral): “782.7 498.4 0.28 0.028 1 Umbrello (2008) 724 683.1 0.47 0.035 1 Lee and Lin (1998) 968 380 0.421 0.0197 0.577 Li and He (2006) 0.00 0.01 0.01 0.01 o a t m i s p d u i o n u w t s t t b fl T t e r f a a a t T T can successfully represent flow stress behavior at low strains.”
- Machining of Titanium Alloy (Ti-6Al-4V)—Theory to Application (2015, neutral): “Umbrello (2008) used the Johnson–Cook’s (J–”
- Finite element simulation of high-speed machining of titanium alloy (Ti–6Al–4V) based on ductile failure model (2011, methodology): “The predicted cutting forces of tests 1–3 are compared with the experimental results measured in literature [12].”
- A new material model for 2D numerical simulation of serrated chip formation when machining titanium alloy Ti–6Al–4V (2008, positive): “Hua and Shivpuri [5] and Umbrello [34] used the Latham–Cockroft model in order to predict the effect of tensile stress on the chip segmentation during orthogonal machining.”
- Mesh influence in orthogonal cutting modelling with the Coupled Eulerian-Lagrangian (CEL) method (2017, background): “Lower numerical forces values with this set of JC parameters have previously been mentioned in the literature (Ducobu et al., 2016b; Umbrello, 2008).”