Machining of micro/miniature dies and moulds by electrical discharge machining—Recent development

By E. Uhlmann, S. Piltz, U. Doll. 2005

171 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/dad554fbe9d3c837b7236cd1ead0618073e04d27

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. A. Razali
2. T. Copponnex
3. P. Mele
4. J. Giboz

In Electrical and Electronic Engineering

1. A. Razali

In Mechanical Engineering

1. A. Razali
2. T. Copponnex
3. P. Mele
4. J. Giboz

Citations in the corpus

• Microinjection molding of thermoplastic polymers: a review (2007, background): “1, diameter of the applied wire electrode d = 30 μm [59], © 2005, with permission from Elsevier.”
• Surface Texture Manufacturing Techniques and Tribological Effect of Surface Texturing on Cutting Tool Performance: A Review (2016, unknown): “However, EDM has limitations; the material removal rate is low, which restricts the size of the workpiece; small values of roughness are achieved with long processing intervals; heat-affected zones on the surface can cause molten material to resolidify by cooling on the surface; and the inability to”
• Micro-manufacturing: research, technology outcomes and development issues (2010, background): “Some generators for micro-electrical discharge machining are capable of impulse frequencies up to 10 MHz [ 10 ].”