Quantitative study of Portland cement hydration by X-ray diffraction/rietveld analysis and independent methods

By Karen L. Scrivener, T. Füllmann, E. Gallucci, G. Walenta, E. Bermejo. 2004

572 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Materials Chemistry

View Paper: https://www.semanticscholar.org/paper/d9789fbca363103e72d168b2258828774a9c79cc

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

In Materials Chemistry

Citations in the corpus

Nano-chemo-mechanical signature of conventional oil-well cement systems: Effects of elevated temperature and curing time (2015, methodology): “Such mass % is typical for hydrated Portland cement as measured with other independent techniques [15,50].”
Effect of mechanical activation on the hydraulic properties of stainless steel slags (2012, result): “The above findings are in accord with other works [50] as well, where comparable values between Rietveld analysis and TGA were found for CH.”
Development and evaluation of methods to follow microstructural development of cementitious systems including slags (2009, methodology): “Definition of degree of hydration of cement by SEM-IA ______________ 87 III.4.4.”
Aluminum-rich belite sulfoaluminate cements: Clinkering and early age hydration (2010, methodology): “Attempts to quantify the hydration processes of cements using XRPD and the Rietveld method have also been published in the last few years [33,34].”
Early hydration and setting of Portland cement monitored by IR, SEM and Vicat techniques (2009, methodology): “Calorimetry is employed to monitor the heat released upon hydration [3–7], whereas X-ray diffraction [8–13], nuclear magnetic resonance [14–16] and Fourier transform infrared spectroscopy, FTIR, are used to”
3D experimental investigation of the microstructure of cement pastes using synchrotron X-ray microtomography (μCT) (2007, methodology): “The figure also shows data obtained from an SEM study, where good control of W/C is possible [16].”
Rietveld Quantitative Phase Analysis of OPC Clinkers, Cements and Hydration Products (2012, unknown): “A key use is to determine the time-evolution of portlandite from RQPA and DTA-TGA measurements (Scrivener et al. 2004; Puertas et al. 2010).”