Advanced Functional Materials

By H. Woo, Hong Li. 2011

656 citations recorded by the source corpus.

View Paper: https://www.semanticscholar.org/paper/d92f8faa125218410e5221c5e0f1f7d3f6a2da30

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Polymers and Plastics

Citations in the corpus

Atomic layer deposition of SnO2 on MXene for Li-ion battery anodes (2017, background): “Ti3C2 is one of the most studied MXene phases because of the well-established etch chemistry involved and the detailed theoretical studies.[18, 19] Furthermore, its large volumetric”
Emerging energy applications of two-dimensional layered transition metal dichalcogenides (2015, background): “[2] Monolayer semiconducting TMDCs with a direct band gap exhibit many distinct properties including strong interaction with light, [18, 19]”
Thermally reduced graphene oxide films as flexible lateral heat spreaders (2014, neutral): “Experimental The details of the measurement technique and indicate the accuracy of the measurements: The measurement of thermal diffusivity and specific heat capacity (CP) refers to the reference[1]”
Review on carbon-derived, solid-state, micro and nano sensors for electrochemical sensing applications (2009, methodology): “Recently, Ly et. al [136] have developed a non-treated blood assay and fast diagnosis method for detection of hepatitis B virus (HBV) using CNT sensor whose mechanical [137] and catalytic [138] properties are specific in this bioassay [139].”
Structural composites for multifunctional applications: Current challenges and future trends (2017, methodology): “One of the mayor drawbacks of VARI, particularly for very large components, is the long infiltration time because of the limited driving force (vacuum pressure).”
Graphene for energy conversion and storage in fuel cells and supercapacitors (2012, methodology): “The PI peak is related to dehydrogenation reaction (HCOOH-CO2+2H + +2e ), while the PII peak is contributed to the dehydration reaction (HCOOH-COads+H2O-”
3D printing of piezoelectric element for energy focusing and ultrasonic sensing (2016, background): “[13-23] Many efforts have been made on applying SLA in ceramics component fabrication, due to its advantages in fabricating complex geometry and high resolution (X-Y resolution<25μm).”
Van der Waals density functional study of the energetics of alkali metal intercalation in graphite (2014, background): “Na-GIC has drawn attention recently due to the potential as anode in a Na-ion battery as an alternative to Li-batteries [11-15].”
Fully biodegradable triboelectric nanogenerators based on electrospun polylactic acid and nanostructured gelatin films (2018, positive): “The BD-TENG, with an area of 4 x 4 cm(2), could generate an output voltage up to 900 V and a peak power density over 5 W/m(2), higher than or comparable to those made from non BD polymer materials [6, 14, 15], yet the devices can be dissolved in natural water completely in about 40 days with no trac”
Transition metal (Fe, Co, Ni, and Mn) oxides for oxygen reduction and evolution bifunctional catalysts in alkaline media (2016, methodology): “One nickel oxide-based catalyst was evaluated for both the ORR and the OER by Liu et al, which was synthesized via pyrolysis to form metal oxide nanoparticles on graphene oxide[44].”
Stitching triple cation perovskite by a mixed anti-solvent process for high performance perovskite solar cells (2017, background): “[1-2] During this process, most works focus on deposition methods, interface engineering, hysteresis in the current-voltage curves of PSCs and the application of new functional materials.[3-12] In order to make it more conducive to practical application, the degradation mechanism”