Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting tools
By R. Arunachalam, M. A. Mannan, A. Spowage. 2004
283 citations recorded by the source corpus.
Subfields: Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/d7074f05ae312d63667710fee5c62815647ff420
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Electrical and Electronic Engineering
- I. S. Jawahir
- W. Li
- Yuebin B. Guo
- José C. Outeiro
- Rachid M'Saoubi
- Mihai Nicolescu
- S. Pervaiz
- Amir Rashid
In Mechanical Engineering
- I. S. Jawahir
- W. Li
- O. Dillon
- José C. Outeiro
- Rachid M'Saoubi
- Yuebin B. Guo
- Mihai Nicolescu
- S. Pervaiz
Citations in the corpus
- Multiple process parameter optimization of wire electrical discharge machining on Inconel 825 using Taguchi grey relational analysis (2013, unknown): “The optimal factor setting is A1, B1, C1, D1, E1, F2, G2, and H2, Similar results were observed by the others during machining of this alloy at higher cutting speeds [25, 26].”
- Analysis of tool wear patterns in finishing turning of Inconel 718 (2013, background): “Cubic Boron Nitride (CBN) cutting tools give good performance and considerable increment in cutting speed when machining nickel-based alloys due to their notch wear resistance, however it should be considered their elevated cost [6,7].”
- Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review (2014, methodology): “[56] performed face milling experiments on Inconel 718 using mixed ceramic-based and cubic boron nitride (CBN) tools.”
- A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, background): “…cracking, metallurgical transformation, plastic deformation, increased microhardness, increased surface roughness and the formation of tensile residual stresses (Arunachalam et al., 2004a, 2004b; Ezugwu et al., 1999; Sadat, 1987; Sharman et al., 2006; Schlauer et al., 2002; Dudzinski et al., 2004).”
- SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS (2009, background): “( 2004a ) investigated the influence of CBN and mixed alumina ceramic tools on the RS when facing age hardened Inconel 718.”