Size effect and tool geometry in micromilling of tool steel
By A. Aramcharoen, P. Mativenga. 2009
404 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/d593491eaf7b23edb6cf90069e00ab3c9c8bf6ca
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- Thanongsak Thepsonthi
- Tugrul Özel
- M. Hasan
- Zhengyi Jiang
- Jingwei Zhao
- Yigit Karpat
- Kapil Kumar Gupta
- R. Laubscher
In Electrical and Electronic Engineering
- Tugrul Özel
- Thanongsak Thepsonthi
- M. Hasan
- Zhengyi Jiang
- Jingwei Zhao
- Kapil Kumar Gupta
- R. Laubscher
In Mechanical Engineering
- Thanongsak Thepsonthi
- Tugrul Özel
- M. Hasan
- Zhengyi Jiang
- Jingwei Zhao
- Yigit Karpat
- É. Rivière-Lorphèvre
- François Ducobu
Citations in the corpus
- A review of modern advancements in micro drilling techniques (2017, background): “[190] have reported that increase in cutting edge radius lead to size effect and can substantially influence cutting forces, chip formation, chip thickness and the quality of wall surface finish.”
- Multi-objective process optimization for micro-end milling of Ti-6Al-4V titanium alloy (2012, background): “Many studies on micro-milling have shown that burr formation is very difficult to avoid; however, selecting appropriate process parameters and tool geometry can minimize the effect to an acceptable level [2, 6, 20, 34].”