Fabrication and evaluation of carbon nano fiber filled carbon/epoxy composite

By Yuan-yuan Zhou, F. Pervin, V. Rangari, S. Jeelani. 2006

180 citations recorded by the source corpus.

Subfields: Materials Chemistry, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/cdc5688d03a94901eb204c90ebc2687fb05de79b

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Materials Chemistry

1. Yuan-yuan Zhou
2. Chuanwei Miao
3. S. Jeelani
4. Arash Montazeri
5. W. Hamad

In Mechanical Engineering

1. Chuanwei Miao
2. W. Hamad

Citations in the corpus

• Mechanical properties of multi-walled carbon nanotube/epoxy composites (2010, result): “Similar results have been reported in the literature [6,16,24].”
• Improvement in electrical, thermal and mechanical properties of epoxy by filling carbon nanotube (2008, background): “The uniform dispersion of CNF was observed in sonication process [8].”
• Effect of dispersion conditions on the thermo-mechanical and toughness properties of multi walled carbon nanotubes-reinforced epoxy (2012, unknown): “In previous studies, [55–57], an increase in the rubbery modulus (between 150 C and 200 C) was also observed, which was attributed to the reinforcing effect by the CNTs, the increased crosslink density and restricted mobility from enhanced polymer – CNT interactions.”
• Mechanical Performance of CNT-Filled Glass Fiber/Epoxy Composite in In-Situ Elevated Temperature Environments Emphasizing the Role of CNT Content (2016, background): “Among the four composite systems, the GE composite exhibits the lowest peak factor as can be seen from figure 13 (c) which concludes that the crosslinking density is highest in the GE composite [40].”
• Cellulose reinforced polymer composites and nanocomposites: a critical review (2013, background): “…composites use thermosetting resins and polymers, like unsaturated polyester (Vilay et al. 2008), phenolic resin (Zarate et al. 2008), epoxy resin (Zhou et al. 2006) and rubber (Setua and De 1984), and thermoplastic polymers, such as poly(ethylene) (Lu et al. 2007), poly(propylene) (Rezaei et al.…”