Materials by Design

By A. Turner. 2008

307 citations recorded by the source corpus.

View Paper: https://www.semanticscholar.org/paper/c775fafbef1fc2f5cb91439ae7f679c7cbf6c51b

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Citations in the corpus

The microstructure and mechanical properties of selectively laser melted AlSi10Mg: The effect of a conventional T6-like heat treatment (2016, methodology): “Various mechanical properties of SLM parts made from Al alloys have been reported in the literature, such as tensile behaviour [19, 22-24], micro-hardness [21, 23], impact resistance [21], and fatigue performance [22, 25].”
Phase separation of metastable CoCrFeNi high entropy alloy at intermediate temperatures (2016, methodology): “Moreover, elements with larger atomic size were also used to strengthen the CoCrFeNi base and many new alloys were designed, such as CoCrFeNiNbx [22-24], CoCrFeNiTix [21] and CoCrFeNiMox [7].”
Effect of the build orientation on the mechanical properties and fracture modes of SLM Ti–6Al–4V (2014, background): “3 near fully dense products, most of the studies of CP-Ti and α/β Ti alloys manufactured by SLM have focussed primarily on the densification mechanisms during the fabrication process [17-20].”
Wettability versus roughness of engineering surfaces (2011, methodology): “In this paper authors experimentally investigate the roughness influence on contact angle measurements and propose a simple modl c mbining Wenzel and Cassie-Baxter theories with s mple 2D roughness profile analysis.”
Mg-Ca binary alloys as anodes for primary Mg-air batteries (2018, background): “On one hand, it has been claimed that solid film on grain boundaries is likely to be more stable compared to the bulk surface [38, 39], while grain boundaries can also act as corrosion barriers [40, 41].”
A simple auxetic tubular structure with tuneable mechanical properties (2016, methodology): “Recently, Mohsenizadeh et al [8] concluded that auxetic foam-filled square tube is superior to empty and conventional foamfilled square tubes in terms of crashworthiness indicators through experimental method, and Hou et al [9] obtained the optimal Poisson’s ratio of the filled material for three fo”