Mechanical behaviour of ABS: An experimental study using FDM and injection moulding techniques

By M. Dawoud, I. Taha, S. Ebeid. 2016

551 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Fused Deposition Modelling of Fibre Reinforced Polymer Composites: A Parametric Review (2021, background): “[56] ABS 1800 250 120 [0/90], [30/60], [±45], [75/15] 0.”
Effect of infill pattern and infill density at varying part orientation on tensile properties of fused deposition modeling-printed poly-lactic acid part (2019, background): “Dawoud et al.6 studied the effect of raster angle and air gap on tensile, flexural and impact properties of FDM-printed ABS part and also made a comparison with the injection molded ABS part.”
FDM-Based 3D Printing of Polymer and Associated Composite: A Review on Mechanical Properties, Defects and Treatments (2020, background): “[43], it was observed that since there is no pressure applied during the process of FDM, the final parts contain more void regions inside the printed structure.”
Effects of Raster Orientation, Infill Rate and Infill Pattern on the Mechanical Properties of 3D Printed Materials (2017, methodology): “[9] investigate the effect of processing technique on the mechanical behavior of virgin ABS, specifically different combination of raster angles and air gap in each printing layer of FDM components.”