Automated Modeling of Three‐Dimensional Structural Components Using Irregular Lattices

156 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Topology optimization using polytopes (2013, methodology): “Following the guidelines discussed in [40,41], a polyhedral discretization is obtained from the Voronoi diagram of a given set of seeds and their reflections about the closest boundary of Ω , i.”
Influence of aggregate size and volume fraction on shrinkage induced micro-cracking of concrete and mortar (2008, background): “Different material phases are modelled by placing nodes strategically, so that cross-sections of 119 lattice elements form the boundary between the phases [29].”
PolyMesher: a general-purpose mesh generator for polygonal elements written in Matlab (2012, methodology): “As shown by Bolander et al. (Bolander and Saito 1998; Yip et al. 2005), a polygonal discretization can be obtained from the Voronoi diagram of a given set of seeds and their reflections.”
Polygonal finite elements for topology optimization: A unifying paradigm (2010, methodology): “The procedure proposed in [8, 13] is summarized as follows: 1.”