Influence of Ranque-Hilsch vortex tube and nitrogen gas assisted MQL in precision turning of Al 6061-T6

By Mozammel Mia, GurRaj Singh, Munish Kumar Gupta, Vishal S. Sharma. Precision engineering, 2018

203 citations recorded by the source corpus.

Abstract Dry machining is undesirable to produce precision surface due to thermal adversities especially for a low melting point material such as Al 6061-T6. Likewise, the conventional flood cooling is neither economically viable nor eco-friendly. In this context, three novel cooling-lubrication (C/L) technologies namely the nitrogen gas cooling (NGC), nitrogen gas assisted minimum quantity lubrication (NGMQL) and Ranque-Hilsch vortex tube (RHVT) NGMQL are investigated along with the air cooling (AC) in turning with an attempt to reduce surface roughness (Ra) and tool flank wear (VBmax). The machining was conducted using uncoated WC insert at two-levels of cutting speed and feed rate; and, as medium of cooling/lubrication the nitrogen gas and/or canola oil is employed. The SEM and 3D topographic images were analyzed for the machined surfaces, worn tool surfaces and chips. Results showed that the RHVT-NGMQL revealed the least surface roughness and tool wear (∼75% improvement compared to other C/Ls). Notable wear modes were: in dry cutting the plastic deformation, BUE and adhesion; in NGC the BUE; in NGMQL the rubbing and adhesion; in RHVT-NGMQL the adhesion. In micro-level, no significant difference in chip structure was found for the studied C/L methods In addition, the Composite Desirability optimization was adopted to systematically minimize Ra and VB max concurrently. It was found that the optimum speed vc = 160 m/min and feed rate f = 0.06 mm/rev under RHVT-NGMQL C/L condition has the potential to generate a precision surface with a roughness value

Subfields: Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/bde8d8cc68d03e434757e7e018202512092bf571

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Mechanical Engineering

  1. Ç. Yıldırım
  2. M. Sarıkaya
  3. T. Kıvak
  4. Şenol Şirin
  5. Ș. Karabulut

Citations in the corpus