Evaluation of tool wear when machining SiCp-reinforced Al-2014 alloy matrix composites

By I. Çiftci, M. Turker, U. Şeker. 2004

211 citations recorded by the source corpus.

Subfields: Aerospace Engineering, Ceramics and Composites, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/b2338d93d9403770d3d8f37b1044cef261f1f409

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Ceramics and Composites

1. J. A. Arsecularatne
2. A. Pramanik
3. Liangchi Zhang

In Mechanical Engineering

1. A. Pramanik
2. Liangchi Zhang
3. J. A. Arsecularatne
4. A. Velayudham
5. M. Seeman
6. G. Ganesan
7. R. Karthikeyan
8. N. Muthukrishnan

Citations in the corpus

• Study on tool wear and surface roughness in machining of particulate aluminum metal matrix composite-response surface methodology approach (2010, background): “Ibrahim Ciffchi et al. [ 5 ] studied the effects of SiC volume fraction and its size together during turning of SiC reinforced 2014Al alloy MMC and found that coated cutting tools performed better than uncoated cutting tools in terms of tool wear and uncoated cutting tools produced better surface fi”
• An FEM investigation into the behavior of metal matrix composites: tool-particle interaction during orthogonal cutting (2007, background): “It was also reported that flank wear increases with the increase of speed [30,31] and at high speeds, chipping of cutting edge becomes prominent [31].”