Additive manufacturing of carbon fiber reinforced thermoplastic composites using fused deposition modeling

1,597 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

3D Printing of Continuous Carbon Fibre Reinforced Thermo-Plastic (CFRTP) Tensile Test Specimens (2016, methodology): “Methods used were impregnation [6], mixing and extruding [7], and fused deposition modelling [8].”
Tensile properties and failure behavior of chopped and continuous carbon fiber composites produced by additive manufacturing (2019, methodology): “Similar to other works [14][26][27], the specimens were held in place using wedge clamps and tested at a crosshead speed of 5 mm/minute as per ASTM D638 standard.”
Improving flexural characteristics of 3D printed geopolymer composites with in-process steel cable reinforcement (2018, background): “Embedding continuous reinforcement in addictive manufacturing was first described in FDM printers, printing carbon fiber in a thermoplastic matrix [24].”
Improving mechanical properties of continuous fiber-reinforced thermoplastic composites produced by FDM 3D printer (2018, background): “Ning et al.18 added carbon-fiber powder with a diameter size of 7.2 micron and lengths of 100 and 150 microns to the ABS filament in order to increase mechanical properties of the printed parts.”
Fused Deposition Technique for Continuous Fiber Reinforced Thermoplastic (2017, background): “The addition of discontinuous fillers generally leads to increase of stiffness, while adverse effects over strength, brittleness and fatigue behavior are usually registered [8-10].”