MACHINABILITY OF NICKEL-BASED HIGH TEMPERATURE ALLOYS
By R. Arunachalam, M. A. Mannan. 2000
308 citations recorded by the source corpus.
Subfields: Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/afc48075bb03f5010a846c9bf7d5153681347088
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Electrical and Electronic Engineering
In Mechanical Engineering
- I. S. Jawahir
- O. Dillon
- José C. Outeiro
- Rachid M'Saoubi
- H. Chandrasekaran
- J. Hughes
- A. Sharman
- Y. Kaynak
Citations in the corpus
- A comparative study of the cutting forces in high speed machining of Ti–6Al–4V and Inconel 718 with a round cutting edge tool (2009, unknown): “However, because of their high strength and low thermal conductivity (Nabhani, 2001; Arunachalam and Mannan, 2000), HSM of these two materials often cause numerous problems in modern manufacturing.”
- Study of surface quality in high speed turning of Inconel 718 with uncoated and coated CBN tools (2011, background): “Many previous investigations have reported that nickel-based superalloys are difficult to machine [ 5 , 6] due to the following several reasons: (1) high hot hardness and strength causing deformation of the cutting tool; (2) the rapid work hardening causing severe notch wear; (3) presence of primary”
- A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, background): “As a consequence, uncoated cemented carbide cutting tools are widely used in finishing operations of critical components in nickel-based alloys owing to concerns about the residual stresses produced with other tool materials and their associated operating parameters (Arunachalam and Mannan, 2000).”
- Workpiece Surface Integrity and Tool Life Issues When Turning Inconel 718™ Nickel Based Superalloy (2004, background): “Arunachalam and Mannan (2000) stated that finishing operations on flight critical aerospace parts are currently conducted using uncoated WC tools at relatively low cutting speeds due to concerns about the surface integrity produced with other tool materials and their associated operating parameters.”