Influence of shoulder geometry on microstructure and mechanical properties of friction stir welded 6082 aluminium alloy

By A. Scialpi, L. D. Filippis, Pasquale Cavaliere. 2007

391 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

The effect of post-weld heat treatment on the mechanical properties of 2024-T4 friction stir-welded joints (2010, methodology): “zone because of the dissolution and growth of strengthening precipitates during the welding thermal cycle [5,9–12].”
Mechanical and metallurgical characterization of friction stir welding joints of AA6061-T6 with AA6082-T6 (2009, background): “In the friction stir welded specimens, fracture occurred near the weld edge line, corresponding to the transition between the thermo-mechanically affected zone (TMAZ) and the heat affected zone (HAZ) and characterised by the lowest hardness as demonstrated in Fig. 2, a feature also documented in [ 1”
Influence of friction stir welding parameters on the microstructural and mechanical properties of AA 6016-T4 thin welds (2009, background): “In most of these studies the thicknesses of the plates joined ranged from 3 to 6 mm and only few of them focused in the FSW of very thin plates, less than 2 mm thick [40, 44 ,45,60].”