The application of research on powder mixed EDM in rough machining

By W. Zhao, Qingyu Meng, Z. Wang. 2002

350 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/adb59229393effd7e53f2ea46fa234171a4656ed

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

A review on current research trends in electrical discharge machining (EDM) (2007, methodology): “[54] using Al with 40 g/l and 10 mm granularity and they discovered that machining efficiency was improved from 2.”
Multi-response optimization of EDM with Al–Cu–Si–TiC P/M composite electrode (2009, result): “In some recent studies [14–18], C, Si, SiC, Al, Al2O3, Ni, Ti, Cr, and Cu powders have been mixed with the dielectric powder mixed EDM (PM/EDM) to improve machining performance.”
Effect of dielectric fluid with surfactant and graphite powder on Electrical Discharge Machining of titanium alloy using Taguchi method (2015, background): “009 When graphite powder is added to dielectric fluid, high pressure acts on the machined zone and causes an increase in the discharge channel gap and plasma channel [40].”
Review of research work in sinking EDM and WEDM on metal matrix composite materials (2010, critical): “The mechanism of this process is totally different from the conventional EDM [43].”
Influences of Process Parameters on MRR Improvement in Simple and Powder-Mixed EDM of AA6061/10%SiC Composite (2015, background): “[14] reported 70% enhancement in machining efficiency in powder-mixed electrical discharge machining (PMEDM) of steel using aluminum powder in special working fluid.”
Effect of the powder concentration and dielectric flow in the surface morphology in electrical discharge machining with powder-mixed dielectric (PMD-EDM) (2008, methodology): “[25].”
A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix composites (2020, background): “It can improve the SR and is now applied in the finishing stage [243].”