Factors affecting the machinability of GFR/epoxy composites
By I. El-Sonbaty, U. Khashaba, T. Machaly. 2004
347 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/a879fa430f1d8ddcea2bd6123b3a28b5ca1beaf2
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- U. Khashaba
- R. Zitoune
- J. Paulo Davim
- V. Krishnaraj
- K. Palanikumar
- K. Panchagnula
- Kuppan Palaniyandi
- N. Elanghovan
In Electrical and Electronic Engineering
- R. Zitoune
- K. Palanikumar
- J. Paulo Davim
- V. Krishnaraj
- U. Khashaba
- K. Panchagnula
- Kuppan Palaniyandi
- N. Elanghovan
In Mechanical Engineering
- U. Khashaba
- J. Paulo Davim
- R. Zitoune
- K. Palanikumar
- V. Krishnaraj
- K. Panchagnula
- Kuppan Palaniyandi
- Arun Ramanathan
Citations in the corpus
- Analysis on Drilling of Glass Fiber–Reinforced Polymer (GFRP) Composites Using Grey Relational Analysis (2012, background): “During drilling, the force in the axial direction through the slope of the drill results in separating the laminas from each other and forming a delamination zone [28, 29] and this can be reduced by reducing the thrust force.”
- Natural fiber–reinforced composites: A review on material, manufacturing, and machinability (2019, background): “At this stage, matrix can deform easily and make a smooth cutting surface.(115) Drill diameter combined with feed rate has a greater effect on delamination and surface roughness when it is compared to spindle speed during drilling of hemp fiber–reinforced composite (HFRC) laminates.”
- Optimization of machining parameters at high speed drilling of carbon fiber reinforced plastic (CFRP) laminates (2012, background): “and reduces the structural integrity of the material [12].”
- Drilling of polymer matrix composites: A review (2013, background): “The peeling force is a function of tool geometry and friction between the tool and workpiece.(6)”
- Assessment of delamination in composite materials: A review (2016, methodology): “This is delamination measure proposed by Khashaba and colleagues.(12) The difference between the maximum radius of the damaged area (Rmax) and the radius of the drilled hole (R) is defined as the delamination size, as shown schematically in Figure 6.”
- Drilling on fiber reinforced polymer/nanopolymer composite laminates: a review (2017, methodology): “Generally, when the drill tool is commerce with the FRP laminate, the drill chisel edge generates a nominal thrust force in the axial direction and subsequently initiates the surface deformation due to the frictional rubbing action of tool and work-piece [20,21].”